1995 chevy blazer
The abs light problem is more than likely a faulty speed sensor as for engine cutting off sounds like a low fuel pressure problem.Check the fuel pressure it should be 60-66 psi with the key on engine off.Also check the fuel pressure regulator for proper operation these regulators are known for causing this problem.
SOURCE: 2001 chevy s10 blazer abs light stays .
The abs is a add on for the brakes that when the tires come into a skid or slid they wont lock up..Your brakes will still work great with the abs disabled but your brakes will lock up if you push on the brakes hard enough to stop.Mainly abs works in slippery conditions not letting the tires lock up and keep the car rolling instead of making it slide..But no effect of the brakes will happen..Just make sure your fluid is full and there are no leaks and if you want to get them check you can stop by your local Auto Zone and they will scan your car for free and tell you what sensor is bad..I hope this was helpful to you...Have a great night
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: 1995 chevy blazer running bad shooting an EGR code,
Hook up a fuel pressure guage. Now with the key on and engine off does the fuel pressure come up fast and hold steady at a fixed value?
SOURCE: 2005 CHEVY +TRAIL BLAZER ABS AND BRAKE LIGHTS ON
if chains caused problem and you have driven with them off light would have gone out once it saw everything working properly. look at sensors might have pulled a wire loose with chains. the abs system runs a self test everytime you start vehicle if it sees a history code from last time it will leave light on and look to see if that problem still exists and 99% of the time it will cut light off . but need to have scanned and checked out
SOURCE: 2005 CHEVY +TRAIL BLAZER ABS AND BRAKE LIGHTS ON
When the ABS light is on when driving there is a problem in the anti lock brake system and you will need to have it tested to find out what the problem is. As long as the light is on the ABS has been shut off by the computer until it is repaired. There could be problems with one of the wheel speed sensors, wiring or the ABS pump. On some vehicles the red brake light will come on too.
SOURCE: delco radio in 95 blazer
With key in "on" position, but pickup not started, press the "SET" button and the "channel up" button (aka "TUNE +"). "SET" appears in radio window.
Now the "SEEK" button will increment hours and the "SCAN" button will increment minutes.
Once correct time is set, press "SET" button again to get out of clock set mode. "SET" will disappear from radio window.
373 views
Usually answered in minutes!
×