Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Apr 21, 2012

Maf sensor location on a previa 2.0 d4d - Previa Toyota Cars & Trucks

5 Related Answers

jmeyer847

Jeremiah Meyer

  • 204 Answers
  • Posted on Dec 06, 2008

SOURCE: MAF SENSOR

Usually this is located on the pipe that comes off the air filter. It can also be located on the intake manifold itself, however the majority of the time its on the pipe coming from the air filter.

Sincerely,

JC

Ad

Anonymous

  • 1 Answer
  • Posted on Feb 16, 2009

SOURCE: trying to locate MAF sensor

Look near your A/C system and under the overflow hose for the coolant. It is a round can looking thing with a small wiring harness attached on top. There rae 3 hex screws holding it on to the bracket. Remove these and slip it off of the air intake tube. Use a small screwdriver to depress the small latch on the inside of the harness and gently pull it off. Disassemble the MAF sensor from the mounting plate, remove it from the vehicle and spray the wires with carburetor cleaner several times. That should clean it up for you. Good luck and let me know if you need more info.

emissionwiz

Marvin

  • 85242 Answers
  • Posted on May 22, 2009

SOURCE: TRYING TO LOCATE MAF SENSOR

THE MAF SENSOR IS IN THE AIR INTAKE HOSE TO THE ENGINE FROM THE AIR CLEANER BOX

Anonymous

  • 158 Answers
  • Posted on Jul 02, 2009

SOURCE: I need the location of MAF sensor in a 1998 Dodge

Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

mickha2

Michael Khait

  • 145 Answers
  • Posted on Aug 17, 2010

SOURCE: need to know toyota previa cranks sensor

behind crank pulley

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

3.0 d4d fortuner not stating,it gives me p1604 fault code

For a Toyota, it indicates a startability problem, it is a very vague diagnostic troubleshoot code and therefore not component specific.

Components to check, Crank Shaft Position sensor, Spark Plugs, MAF sensor, fuel pump... etc.
1helpful
1answer

Toyota d4d fortuner not starting fault code p1604

For a Toyota, it indicates a startability problem, it is a very vague diagnostic troubleshoot code and therefore not component specific.

Components to check, Crank Shaft Position sensor, Spark Plugs, MAF sensor, fuel pump... etc.
0helpful
1answer

Where is the ect sensor on a 1995 toyota previa

There are three temperature sensors on a 95 Previa engine. They are located on the left front side of the engine. The lower one is somwhat accessable from under the vehicle but access to the other two will require removal of the passenger seat and the access cover under the seat.

Read more: http://wiki.answers.com/Q/Where_is_the_temperature_sender_or_temperature_sensor_on_a_1995_Toyota_Previa#ixzz25j6FLDP8
0helpful
1answer

HOW DO I REMOVE THE ROCKER COVER ON TOYOTA PREVIA D4D 2004 ONWARDS

remove the injector pipes and the guide tubes around them be careful not to crack them they will cause a bad oil leak
0helpful
1answer

Where is located the cam position sensor on a 94 Toyota previa?

up to 1994 Previa's the cam sensors are located in the distributor, there is one for each cam. labeled G1 & G2 which are the center 2 of the 4 wires to the distributor, if you want to test them first.
Also, top wire is crank sensor, bottom is ground.

I believe you will have to replace the whole distributor.
1helpful
1answer

What is tps or maf sensor

tps is a throttle positioning sensor on the throttle body

maf is a mass air flow sensor which is mounted on the air intake to the air snorkle to the air filter tubing
1helpful
2answers

Location of mass air flow sensor on a 2002 pontiac firebird

It should be along the air intake. A block box about 1 1/2" x 2 1/2" held on by 4 ? screws. Easy to replace, but kind of pricey. They make a product for cleaning them. Try that first. Do not touch the wire resistor that goes into the intake. It's delicate.
1helpful
1answer

Where is knock sensor in toyota previa

it has to be located on the engine block its 2 cable sensor
hope this helps
Not finding what you are looking for?

419 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...