Hi hope someone can help me. i took my nissan almera tino 1.8, 2003 for test and its failed on the emissions saying too high, it has some white smoke just started coming out exhaust what could be the problem thanks in advance x
SOURCE: Nissan Sentra 2000 model. Thick White smoke coming out of exhaust
White smoke is caused by coolant or water coming out the tail pipe. There is a chance that the white smoke was caused by water splashing up from a puddle onto the exhaust pipe. Keep an eye on the coolant level in the radiator in any event.
Let us know how it goes or if the problem persists. We're looking forward to how things go for you.
SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working
Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
SOURCE: Clutch shudder and loose gears
It sounds to me like the clutch is slipping or it was not properly adjusted. I would take it back and tell them to take it out for a drive around the block. If they still refuse to do anything about it, take it to another garage and get their opinion. Better yet, get a written estimate. Then take it back to the garage that put the clutch in and tell them either fix the problem for free or you are going to take it elsewhere to get it fixed and sue them in small claims court. I do know that when i replaced my clutch, you need to have about a 100 mile break in. But still, the gears should not be loose and it should shudder. If anything, a new clutch will grab hard with very little play untill it is broke in.
SOURCE: Radio says Secure on Nissan Almera Tino (04)
call a nissan dealership gine them your vin number and they will give u the radio code then u enter it in your radio write it down in ur car somewhere in case it happens again
SOURCE: how do I remove the service spanner symbol from a
Try this: With the ignition ON but radio OFF, press in and hold the INFO button and turn volume control until the menu appears. Now choose CONFIRMATION and Enter. Go down and select SERVICE and press Enter. Select RESET and then Enter. Backup to the main menu and now turn ignition off. This should remove it.
869 views
Usually answered in minutes!
×