SOURCE: 2002 Ford Escape will not shift into drive
This is the shift lock...you will need battery to release it electrically but there is an over ride by the shifter..either a button to push or a place to put your ignition key. This will release the shifter
SOURCE: Ford Escort 1997 Problems shifting gears
the speed sensor is located on the passenger side of the transmission , it has a 2 wire connector and is held down by 10mm bolt and clamp , sometimes the sensor will get stuck in the transmission when trying to remove it . persistence and a little WD-40 will help !
SOURCE: manual transmission takes effort to put in gear.
Have the clutch looked at. If the clutch is not releasing fully it makes shifting difficult. Have the trans fluid changed too, it isn't expensive and probably is listed under your maintanance in the owners manual
SOURCE: my 1997 ford taurus transmission slips when it shifts to second
this is caused by a piston in the transmission that has a crack in it once it warms up the crack seals and operates normally.being cold the crack opens up allowing fluid to flow past it. take to trans shop as soon as you can, will be minimum repair if it has not caused further damage in the transmission.
SOURCE: Need a manual for 2005 FORD BF FALCON.
I really couldn't find one. There's this 2003 ford falcon manual though:
http://pdftown.com/Ford-Falcon-BA-2003-Service-Manual.html
Hope this helps.
REMOVAL AND INSTALLATION (Continued)
Gear Shift - Floor Mounted
Removal
1. Raise the vehicle and disconnect the transmission
shift cable from the lower selector lever.
2. Disconnect the four nuts that attach the housing 6. Remove the whole floor shift housing by lifting
to the floorpan. vertically
Installation
1. To install the floor shift housing to the floorpan
reverse the above instructions in order 6, 5, 4.
2. Place the selector lever in the 'P' position.
3. Raise the vehicle.
4. Reconnect the four nuts that attach the housing to
the floorpan.
5. Install the shift cable back onto the lower selector
lever.
6. Tighten the lock nut to the required torque to 28
Nm.
7. Lower the vehicle and check transmission
operation in each selector lever detent position.
3. Lower the vehicle. 8. Check that the mode light functions correctly. For
4. Remove the centre console (Refer to section further information, refer to Section 307-05.
307-05).
5. Detach the back light bulb/wiring.
BF00006
I6 Floor mount shift components
3,667 views
Usually answered in minutes!
×