The sliding door wiring on my 2001 Chrysler Town & Country has finally quit working all together (with the help of the Chrysler Dealership). They want $500 to replace the door harness. I have seen several posting of people fixing the problem themselves, but I am unable to find the part anywhere. Can someone please direct me to a company that I can purchase a new sliding door harness? Thanks
You need to remove the old harness and open it up then repair the broken wires this will save the old harness and what the other people are talking about
The $500 for parts and labor try to see different dealer and ask them for the harness alone no labor take the harness and installed it is not that hard to put in
SOURCE: My 2001 Chrysler Town & Country passenger sliding door won't open
your door panel can come off and you can access internal door locking mechanism from inside car first inspect to see all rods are hooked into plastic sleeves then make sure lock is disengaged by pulling rod towards rear of van it should then be able to be opened easily if not your locking mechanism is frozen inside of door between a pillar and door it will have to be pushed to open from inside of door panel once you do that door will open if you cant make lock work manually once this is done replace locking mechanism or rods accordingly.
SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: The power lock (driver's side sliding door) on our
Take a look at end of door where latch is & post where the 2 meet when closed. Look for round metal button/contacts, about 1/2" in diameter. If you look close, they should line up to make contact with each other when door is closed. Take some fine steel wool (preferred) or fine sandpaper and scuff them up until you see metal is clean on both surfaces. Now try it, and let me know what happens.
SOURCE: My 2005 Town and Country's right sliding door quit
i just fixed one. it had a broken wire in the harness that moves with the slider, you have to completly pull the harness apart to find it
SOURCE: Power door lock inoperable on passenger sliding door only
Not sure if they are same on 2006 but there should be a couple of small rounded metal contacts, or similar, on door that meet with door post to complete the connection. When you find them, clean them off with a little fine steel wool or SOS pad, minus the soap, and see if that doesn't cure it.
1,459 views
Usually answered in minutes!
Are you sure it's the harness, or is it the motors themselves? I have the motors for my 2001 T&C sitting on my desk right now and found the problem and fixed them. If you have some technical ability, it really isn't too hard.
×