I have a 1992 Jeep Cherokee 4.0 Liter. When I turn the ignition switch off, my jeep will continue running! The starter will not disengage. I'm not sure whether it is the ignition switch, starter, or cylinoid that is bad. Any suggestions as to what might be wrong? I am at my wits end with this problem, Gabe
Chech the ignition contacts, starter solenoid and also the relay
Sounds like soleniod.pull starter & bench test it.lets hope ignition switch is OK.
SOURCE: 1996 jeep grand cherokee 4 x 4 with 5.2 liter v8
under the vehicle...mounted close to the front of the fuel tank...be sure to release the fuel pressure before you disconnect any line..you can do that by removing the fuel pump relay and cranking the engine
SOURCE: how to remove the ignition switch in a 1993 Jeep Cherokee?
The ignition switch or the key cylinder?
SOURCE: 1999 Jeep Grand Cherokee : Replaced Water Pump and Drive Belt now Jeep won't start?
When you replaced the Water Pump, did you replace the Timing Belt? Any time you replace a Water Pump you have to replace the timing belt because it stretches out. If you did not then most likely your Engine is out of time and there for will not start, but it will turn over. hope this helps, good luck.
SOURCE: 2000 jeep grand cherokee 4.0 liter engine timing belt replacement
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
SOURCE: 1994 Grand Cherokee Jeep wont start
It is likely one of your battery cables loose. Same thing just happened to me today. What you need to do is first lock the doors, and close them. Then you need to disconnect, and reconnect the battery cable, then if the security lights still blink you must use your key to unlock the door, then it should stop blinking, and start just fine.
100 views
Usually answered in minutes!
×