Location for starter on 2002 chevy avalanche - 2008 Chevrolet Avalanche

Need to know where the fuel regul?tor is located on. 2002 Chevy Avalanche Need to know where the fuel regul?tor is the located on. 2002 Chevy Avalanche

Follow the larger diameter pipe below your high pressure valve, between that point and the compressor

still won't crank ? how's your battery ? starter ? starter solonoid ? if your engine does'nt crank , its dead ! would'nt you check the battery first ? then move on with checking the starter circuit ? seems like your putting the cart before the horse ! first of all, when you run out of gas, you need to replace the FUEL FILTER, your engine just sucked the dirt, garbage, etc., out of the tank. there's plenty of sediment in the tank, don't know how it gets there, but, you'd be surprized ! talking threw experience !!! I operate heavy equipment, its a cardinal sin to run out of fuel !!! you say you replaced the inline filter, which one, up by the engine or the main filter, under vehicle along frame ? are we talking about the same animal, PLEASE CLARIFY !

Ther is a sensor on the rear end. Take kit out and clean it. This should solve your problem. Located on top of the bell housing

That code is for your knock sensor which is located under your intake manifold. There are two under the intake. I would recommend replacing both, they are 40 dollars a piece usually plus the labor to remove the intake.

Do a bench test on the starter. Remove starter, hook up a ground cable to starter, and positive to two prongs on starter and it should spin. You can do this in vechile too but not suggested due to risk of injury. If it doesn't spin, probally a solenoid or the starter it self. Unlikely but possible.

under the hood by the master brake cylinder

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/thomas_c50676e836a18949

Possible bad engine crank sensor. Electronic Control Module provides initial timing for start then depends on the crank sensor once started for timing and firing

oil pump is on front of engine you ewill need to pull crank pulley and fan shroud.

the knock sensors are under the intake on the valley cover