SOURCE: 1992 Pace Arrow Motor Home 454 Chevy...not getting fuel to start
After you dump the fuel in the throttle body it will continue to run on its own or die as soon as it burns up all the fuel you dump in? Do you have access to (Noid lights)? Are both plugs attached to the distributor?
SOURCE: 1999 chevy blazer fuel problem
probably not fuel filter . probably going to have to remove the upper intake and replace the fuel injector spider(fuel inj assebly) if it is droping fuel pressure it is leaking into the upper manifold
SOURCE: I own a 2000 chevy blazer with a 4.3 v6 vortec. It
did you check power and ground at the fuel pump connector?there should be power at two wires at the connector,one should have constant power with the key on and thats for your fuel gage,the other power wire should have it only when cranking or for about 3-5 seconds when the key is turned on,check both of those first and that will let you know that everything is fine all the way forward of that connector,also did u replace just the pump or the whole sending unit?if you just replaced the pump the connector that runs fron the sending unit to the actual pump itself inside the tank also goes bad on this setup too,look for brown or burn marks on the inside of the sending unit where this connector hooks uo,hope this helps
SOURCE: i have a 1991 corvette, it wont start. i can start
If there is not fuel going thru Fuel injectors, then it won't start. You can buy NOID lights at any auto store to connect to Fuel injectors to see if there is a problem with Fuel injector module. Here how the NOID lights look like:
http://www.tooltopia.com/index.asp?PageAction=VIEWPROD&ProdID=5334&utm_source=shopzilla&utm_medium=cse&utm_term=OTC3050C&utm_campaign=shopzilla_r1
You plug these into the connectors of Fuel Injectors to check during cranking. If there is light then your Fuel iinjectore Module is Good.
Then there is a problem with the Regulator. Here how it look like.
Testimonial: "very good thank you i will try it"
295 views
Usually answered in minutes!
both plugs are attached to the distributor, and yes when i dump fuel into the injectors it dies out
need to know how to clean fuel line checked line and only one line is getting gas after fuel filter
wires on one side of fuel injectors module it has a A and B set up are bad because when i hook up other A and B wires from other side it works any suggestion on how to splice wires and get power to the electrical w/existing help
×