Engine runs well for a time. turn off and when i go back to it the engine management light stays on and will not start. this is an intermitent fault. please help
SOURCE: audi a4 engine management light
Go to AutoZone or Advance Auto Parts and have them scan the ECU (they do it for free, where a shop will charge you). They'll give you the codes, and you can post them here. Once you do that, I can help you narrow it down.
SOURCE: Ford Focus Engine System Fault warning light
yes there is a know problem with the fuel system. fuel pump breaks down, empty your fuel filter into a bowl and check for metalic, if you have this in the filter your pump is F..... along with all the other common rail stuff. expensive job... error codes though, i find that hard to believe, fuel pressure faults will occur, i think you garage does not know what to do. or does not want to tell you the cost of the job and he will be in doubt himself of wether he is right..... was you engine coil light flashing at any point.!!!
SOURCE: XK8 ABS FAULT LIGHT COMES ON INTERMITANTLY PLUS
Number of possibilities. Most likely culprit is wheel bearings. Have these checked. Big heavy car and wheel bearings do take a hammering on XK and XJ's. Once they go, the wheel speed sensors are out of line with the tracking ring and a fault code is thrown. As the TCS uses the same sensor, this also throws a fault. Next in line is the ABS unit (it's hardly ever the main block, but ECU itself, companies on the net offer rebuilt units. Finally it can be the ABS pump unit - but the fault codes will show if this is the case - or you can pull the pump unit plug out of the ABS unit and see if it has continuity with a multimeter - should be a low number of ohms. 8 times out of 10, it is wheel bearing.
SOURCE: v50 hid kit flickers and turns off
Well, I don't have a specific solution to your problems but I found a troubleshooting guide on ebay that might help...hope it helps...
Click Here
112 views
Usually answered in minutes!
×