I need to change my oil changs sequence to 10K from 5K on my 2010 Dodge Caliber

SOURCE: need instuctions to change tail/break lights on 07 dodge caliber

popohead, if people thought it was easy, they wouldn't be here asking. Your reply is useless.

To remove the pins, look a them closely. Notice that there's two little notches cut into the cup that holds the pin. Use a flathead on each side to leveredge them out a little. If that doesn't work at all, you can use a pair of pliers to firmly grip the head of the pin and pull straight out. Quick firm pull.

Once the first pin comes out, the second pin should easily come out. At that point, firmly grip your taillight housing, and pull straight back: Don't try to wiggle it out, and don't try to lift it to one side or the other like a trunk or door. Just pull it firmly straight back like you would a dresser drawer.

Once it's out, the little wiring harnesses come out of the taillight housing with about a 1/4 turn, and the bulbs just slide straight out of those.

Good luck!

SOURCE: Dodge caliber oil viscosity

no it will not cause any harm over the corse of 3000 miles. 5w30 is just a little thicker. 5 is the thickness when oil is cold. 20 or 30 is thickness when oil i hot, it will be ok just dont do any hotroding. only down part is that if the dealer finds out it will void the warranty.

SOURCE: We had the oil changed in the 2008 Dodge Caliber

thats the right oil, something else is wrong.

SOURCE: how to change head light bulbs on a dodge caliber

Park the Dodge Caliber on a flat paved or concrete surface. Turn the steering wheel all the way to the side opposite the headlight you are replacing. In other words, if you are replacing the left headlight, turn the wheel all the way to the right. Apply the parking brake and release the hood latch.

SOURCE: How do you remove a dodge caliber serpantine belt?

take an 11/16 wrench and turn tensioner pulley towards cockpit then slip the belt off of the top idler pulley