2001 Dodge Stratus Logo

Related Topics:

A
Anonymous Posted on Jan 17, 2018

2000 dodge stratus, thump noise increase/decreas while driving,new tires 4,new cv axles,new brakes,new power steering pump installed, but thump sound is still there ?

New tires.new brakes, new power steering pump, does not have alignment problem, engines runs fine...jack up take pressure off tires no thump sound....do not where this is coming from.feels somewhere in te center of the front wheel drive system...but no hestitation or lose of speed from transmission ?

1 Answer

Michael Foth

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

  • Contributor 11 Answers
  • Posted on Jan 17, 2018
Michael Foth
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Joined: Jan 10, 2018
Answers
11
Questions
2
Helped
1059
Points
39

My thought would be to look at the u joints and drive line. When driving the car and it makes the thumbing sound shift to natural, if the sound stops it is probably in drive line.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 03, 2009

SOURCE: 2004 dodge stratus sxt 4 cyl

hey mine does the same thing except only when braking and the problem was cheap rotors that were warping:(

Ad

Anonymous

  • 141 Answers
  • Posted on Feb 06, 2009

SOURCE: 2001 Dodge Stratus noise

did you replace all four tires our only two, what it sounds likes that one off the tires has a slippes belt which in trun has caused a bulge in the tire take it back to whom every installed your tires and have them look for you good luck kdc744

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 23, 2009

SOURCE: 2000 Dodge Stratus....It sounds like the front

U have a seperated cord in the body of tire, this is very dangerous, have a tire shop look at this ASAP

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Mar 25, 2009

SOURCE: 2000 DODGE NEON DRIVER SIDE WHEEL THUMPS ?

Coould be your ball joint. One way to check to see if it is the bearings is to jack the car and grab hold of the tire and give it a twisting motion, one hand on the top of the tire and one hand at the bottom...push/pull type method. You should have almost no play in it whatsoever. Inspect your ball joints. Look for torn boots....means no grease.

If you replaced only one strut, it would be advisable to take the car in for a front end alignment.

Let us know what you find.

aroostookb

aroostookb

  • 98 Answers
  • Posted on Jun 23, 2009

SOURCE: Can power steering pump be removed by taking out

Dropping the strut should be sufficient......

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

My 2000 subaru automatic legacy is making a loud thump noise coming from front of car, what could it be?

Front CV joints, especially if the thumping is worse when turning to the left or right.
0helpful
1answer

Thumping noise in right wheel when driving 02 kia sedona

Try balancing & rotating the tires. If the sound is gone, problem solved. If it is rotated to a different spot theres the answer
0helpful
2answers

Power steering is hard to turn at times, fluid is full, is there a belt other then the serpintine??? i dont see one on the power steering pump

does it make noise when turning ? when installing new power steering pump with both front tires in air on jack stands or jacks start and fully steer right fully steer left repeat a couple times and shut off now pump is bled place on ground and test....by turning take a drive....
4helpful
2answers

Humm in car

Try moving the tire to a different position and see if the sound stays with the tire or stays in the right front. Does it do it when braking, accelerating, driving straight all the time? Also - if you get on a long straight stretch of road with no traffic - switch it to neutral and turn the engine off - REMEMBER - you will lose power steering and brakes with the engine off.
1helpful
3answers

Loud roaring noise in front of dodge stratus ES 2000

i have a 2000 doge straus and i put two sensors in and it still wont shift any ideas out ther it was fine when parked a year ago so i know the tranaxle is good
0helpful
1answer

2000 DODGE NEON DRIVER SIDE WHEEL THUMPS ?

Coould be your ball joint. One way to check to see if it is the bearings is to jack the car and grab hold of the tire and give it a twisting motion, one hand on the top of the tire and one hand at the bottom...push/pull type method. You should have almost no play in it whatsoever. Inspect your ball joints. Look for torn boots....means no grease.

If you replaced only one strut, it would be advisable to take the car in for a front end alignment.

Let us know what you find.
1helpful
1answer

Thumping noise in chevy tracker 2000model

this noise sounds like your right cv axle. wou might want to have that checked out, they can do great damage if broken while
0helpful
1answer

2001 Dodge Stratus noise

did you replace all four tires our only two, what it sounds likes that one off the tires has a slippes belt which in trun has caused a bulge in the tire take it back to whom every installed your tires and have them look for you good luck kdc744
20helpful
7answers

Loud roaring noise in front, steering wheel has vibration, replaced tires didn't help.

Wheel bearings are likly and I've changed many to solve this problem but it's esy to pick the wrong one with e vehical jacked and on jack stands suporting the car by the lower control arms ( normal ride hieght) run the car with a driver and listen to ti run , of course theres no load on the powertrain so there will be some lash ( power on to power decline ) cheack up. The roaring noise can be isolated by puting a sounding bar ( long metal rod ( sr=crew driver)) other against the part till the sound is rounded up rear but possible the carrier bearings in the (rear end) front drive. The axel bearings and on some units the carrier bearing thats in the CV axel on the block. Sounding rod will find and change the noisey part. Professional help is a good idea if you can't carry this out saftly
Not finding what you are looking for?

202 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...