Resetting brake warning lamp 2006 bmw 750 li

In some cases the player communicates via the radio by which all activity generally is computer controlled. The BMW computer brain may need a reset or adjustment. This generally requires a technical tracing by computer at the BMW shop. They have equipment to make adjustment. Sounds easy, but today the manufactures make it hard fro the average individual to make adjustment these days.

The Navigation unit needs to be recoded. Did you replace the unit recently?

If it is like earlier models, open trunk, move rug away from back edge, turn socket to unplug and access bulb.

the ground wire needs to go to a better ground then the strut bolt. find a better thick piece of steel on the engine to ground. those cables look very thin. It should start right away not after 40min. your boosting not charging the battery. if you cant get it started with a better ground location try a thicker set of cables and make sure the other car is running. if this fails your battery needs to be replaced

hi well no not really the transmission and the brakes have absolutely nothing in common. brake booster? ummm..dont think so, master cylinder is a good possibility 2 ways to find that out, check inside under dash where brake pedal is, if its damp there is a good chance its the master cylinder, if not, where the you put the brake fluid, check the under it see if its wet, see if the brake servo has fluid around it as well the other thing it could be is air i the brake line and that could mean something is letting in air the way to check this is, run motor, press brake semi hard, then without taking foot off brake pedal slightly raise your foot ( but keeping pedal down ) then do it again if it starts to "sink" this means there is air in the system hope i have understood your question...

Hi , to reset the service light you will need to insert the key and turn the ignition lights on but do not start the engine. you will see a push button on the lower left side of the instrument panel press and hold this until you have a triangle appear which then turns to the brake warning symbol , release the push button then press and hold the bc button in the indicator arm until reset appears , release and again press and hold the bc button until you have a moving clock symbol appear , release the bc button and wait for the display to change , once this has reset turn off the ignition and the service symbol should have reset . you may want to print these instructions before resetting , regards Mark.

Unfortunately, you have to have the service reset tool. Dealers and BMW mechanics have this tool, but i don't know whether they reset for free. i guess it depends on who you take it to.

Regards,
matt

this needs to be done with a european capable scan tool,check around to see if someone has this tool, no other way sorry

you will require to take the car to a dealer to resett this

the brake pad warning light is controlled by a sensor located in the front and rear brake pads, small contact with 2 wires that plud into a harness, if they are bad I think the replacement cost is around 5-10 dollars for a new one, there will only be one in the front and one in the rear, the service light is turned out by a special tool at the dealer