Where are/is the camshaft location(s) on a 2004 Subaru Baja Turbo? Codes read as bad...
SOURCE: volvo 940 turbo oil control valve location
take off pipe going to the intercooler from the turbo see if oil is found and clean then other pipe from incooler check it .if oil is found .drain oil in intercooler .you have an oil leak from the turbo this is why you will have light on far left of dash
SOURCE: location of the camshaft position sensor in a 2004 mercury sable
it is located on top of the engine right below the air inlet tube at the base of the intake it is a black sensor on top of a silver housing where the distributor would normally be
SOURCE: removing front rotor
I am trying to remove the rear rotors on a 2003 Subaru Baja and need to remove the caliper but one of the bolts holding the caliper is inaccessable with a wrench. How do I remove the second bolt to remove the caliper to rempve the rotor/
SOURCE: Raw gas smell coming from engine copmartment of
think you may be right ,but a 4 yr old vehicle with cracked pipes?? ,lift bonnet and have a look ,then report back
SOURCE: WHERE IS THE CAMSHAFT POSITION SENSOR LOCATED ON A
It is located behind the upper timing belt cover, you should see the wiring harness sticking out.
70 views
Usually answered in minutes!
×