Question about 2010 Dodge Grand Caravan

Open Question

2010 grand caravan driver door lock will not lock or unlock with remote

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
motor1258

Mike Butler

  • 6674 Answers

SOURCE: Door locks dont work

2 things I would try before replacing an expensive BCM. Disconnect your battery for 5 minutes or so, then reconnect, and see if that helped at all. I have heard in some cases it worked successfully. If that doesn't cure it, I would go to the plug on the BCM itself, (with battery disconnected) and pull the plug off, inspect it, and clean it & mating pins on BCM very thoroughly with contact cleaner or similar electrical cleaner. Add a little di-electric grease to connection & put it back together nice & tight & see what happens. The BCM is usually located on passenger side in kick panel area,(by right foot when sitting) either behind kick panel or above it.

Posted on Mar 15, 2009

Ad

Anonymous

  • 2 Answers

SOURCE: 2002 Dodge Grand Caravan Driver Door Lock/Unlock Switch

sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
http://www.dodge.com/bodybuilder/2004/docs/wd/rswd/tc.pdf
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.

Posted on Apr 21, 2009

Anonymous

  • 2 Answers

SOURCE: 2006 Dodge Grand Caravan

Actually this sounds like the actuator inside the door is to blame.  Basically a small motor/gearbox assembly tied to the door lock mechanism.  I had one die under warranty.  Same symptoms you described.  The dealership changed it, charging 0.2 hours of labor against the warranty.  Basically, remove the inside trim panel from the door, unbolt/disconnect the old actuator, and install the replacement.

Posted on May 25, 2009

fixitriteman

Ray Shepherd

  • 431 Answers

SOURCE: 2008 Grand Caravan won't start. The lock/unlock

Check see if crank fuse blow / also check see if any thing around battery could be louse /you may need to test wire at starter is getting power when key is in start position/ large wire should always have power / small wire only when key is in the start position. should you have any further questions feel free to ask we are here to help Thank You .

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power lock drivers sliding door lock wont unlock


the lock is in door mechanism that holds the door closed

Jan 03, 2016 | 2010 Dodge Grand Caravan

1 Answer

Door locks by themselves .wont unlock are lock with remote


change the batteries in the remote , it may need to be re-programmed for the car , good luck

Mar 15, 2015 | 2010 Dodge Grand Caravan

1 Answer

Some of my doors will lock and unloc by remote and som will not how do I fix this


do they work when using the master switch on the drivers door panel? if only the drivers door unlocks when pressing the button, it may be a personal setting change needed. in this case usually pushing the unlock button on the remote twice will then unlock all doors. if there is only one lock that doesn't work it is most likely the door lock actuator that is at fault or a broken wire in the door opening wiring harness of the door that the lock does not work on.

Mar 22, 2014 | 2010 Jeep Liberty

1 Answer

Power door locks do not work


2004-2005 CARAVANS HAD A SOFTWARE ISSUE IN THE BODY CONTROLLER..REMOVING AND REINSTALLING IOD FUSE IN UNDERHOOD FUSEBLOCK..THERE IS A SOFTWARE UPDATE FOR THE BODY CONTROLLER FROM CHRYSLER..TAKES ABOUT AN HOUR TO COMPLETE..AS FAR AS I KNOW,THEY ARE ONLY ONES WHO CAN DO THIS

Sep 23, 2009 | 2005 Dodge Grand Caravan

2 Answers

Grand caravan sliding doors problems


the door track cable on the right side will have a broken wire in it,the drivers side will be the door control module inside the door

Aug 01, 2009 | 2006 Dodge Grand Caravan

2 Answers

2002 Dodge Grand Caravan Driver Door Lock/Unlock Switch


sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
http://www.dodge.com/bodybuilder/2004/docs/wd/rswd/tc.pdf
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.

Apr 04, 2009 | 2002 Dodge Caravan

1 Answer

Sliding door lock


If you check the doorlock actuator it is more than likely bad. On my caravan I had to replace actuators on both sliders. Cannot get correct actuators at autoparts stores. Either go to a salvage yard or to the dealer to get them.

Jun 13, 2008 | 2002 Dodge Grand Caravan

Not finding what you are looking for?
2010 Dodge Grand Caravan Logo

Related Topics:

5,114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...