Question about 2004 Hyundai Santa Fe
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
not sure it should happen that fast but it may.... buy yourself a couple bottles of gas line antifreeze and put them in the gas tank... sounds like you have a lil water problem ... this stuff is basically alcohol (not the kind you drink) and it will suck up the water.
Please take a moment to rate this solution
Posted on Jan 30, 2009
SOURCE: turn on switch fuel pump"
There is not a Switch for the Fuel Pump. Look under the Hood and Locate the Fuse Relay Box. Inside this Box is a Relay for the Fuel Pump. The Diagram should be inside the Box Cover or Inside the Owners Manual. Replace this Relay and it should Start unless the Fuel Pump needs to be Replaced. Please Rate My Response! Thanks!
Posted on Feb 05, 2009
SOURCE: wont start
This a possible solution. My 2004 just killed on the way to work 3 weeks ago. It would turn over, but would not start. When my mechanic looked at it, I told him I thought it was the fuel pump, because that is how it seem to be acting. As if the pump was not sending fuel. Turns out it was a sensor behind the timing chain. The Cam Shaft sensor. Once that goes I guess it cuts the fuel. Hyundi's have a maintance schedule where you need to replace the timing chain at 40,000. It was the slack in the belt that caused the sensor to go. I had the two belts the the cam shaft sensor and one other sensor in that same place replaced and now it runs like a top. I hope that helps. And I hope that is not your problem. Parts were pretty cheap. But with labor it cost $900.
Posted on Mar 06, 2009
Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.
Posted on Jun 17, 2009
Tips for a great answer:
Feb 13, 2018 | Cars & Trucks
Jan 24, 2016 | Hyundai Cars & Trucks
Aug 07, 2011 | 2004 Pontiac Sunfire
Sep 13, 2010 | 2004 Hyundai Santa Fe
Sep 04, 2010 | 2003 Hyundai Santa Fe
Feb 25, 2010 | 2004 Hyundai Santa Fe
Sep 07, 2009 | 2004 Hyundai Santa Fe
May 18, 2009 | 2004 Hyundai Santa Fe
May 02, 2009 | 2004 Hyundai Santa Fe
Jan 11, 2009 | 2004 Hyundai Santa Fe
47 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: