SOURCE: i lost my key and
Here is the factory procedure to program a new key(s), I recomment only factory keys, you need to use the working key to do the procedure;
1. Insert a previously programmed coded key into the ignition.
2. Turn the ignition from the 3 (OFF) position to the 4 (ON) position. Keep the ignition in the 4(ON) position for at least one second, but no more than 10 seconds.
3. Turn the ignition to the 3 (OFF) position, and remove the coded key
from the ignition.
4. Within ten seconds of removing the previously programmed coded key, insert the other previously programmed coded key into the ignition.
5. Turn the ignition from the 3 (OFF) position to the 4 (ON) position. Keep the ignition in the 4 (ON) position for at least one second but not more than 10 seconds.
6. Turn the ignition to the 3 (OFF) position, and remove the second key from the ignition.
7. Within twenty seconds of removing the previously programmed coded key, insert the unprogrammed key (new/valet key) into the ignition.
8. Turn the ignition from the 3 (OFF) position to the 4 (ON) position. Keep the ignition in the 4 (ON) position for at least one second.
9. Your new unprogrammed key is now programmed. If the key has been successfully programmed it will start the vehicle’s engine and the theft indicator light will illuminate for three seconds and
then go out. If the key was not successfully programmed, it will not start your vehicle’s engine and the theft indicator light will flash on and off rapidly. If failure repeats, bring your vehicle to your dealer to have the
new key(s) programmed.
To program additional new unprogrammed key(s), repeat this procedure
from step 1 for each additional key
SOURCE: Replacement of PCM on 1999 ford Explorer
just use google... i would suggest pcm programming ford to start
Robert
SOURCE: GEM module replacement
try a salvage yard that has an expedition or an f150 pickup and take the parts off and install in yours disconnect the negative side of the battery and you shouldn't have to have it reprogrammed
SOURCE: I need to reprogram 2008 Ford Escape Key-pad.
u can try this, it is for an explorer but should be the same.
This information will be in your owners manual I think.
1. Type in the code you got when you purschased the vehicle
2. After typing in the code press "1" on the keypad
3. Enter in your new code
4. The doors should lock and unlock if this is done correctly
SOURCE: Ford Focus 2001 ABS, Traction Control and Emergency Breake lights
You need to get a diagonstic check as sooon as the light comes on, dont turn ignition off as thi may delete the fault code Good luck Davelee
301 views
Usually answered in minutes!
×