95 Ford Explorer power window won't come up

Iron

• 3018 Answers
• Posted on Oct 28, 2011

SOURCE: I have a 1998 ford explorer and sometime at the

• You need to open up the drivers side door and look at that harness that stretches between the door and the door frame. Inside that harness are the wires for the electronics in the cabin and then some.

• Over time those wires get pinched and crack and break. So you need to splice the casing (or just simply slide the harness to one side and then the other) open the long ways and inspect the wiring. Your looking for broke, split, rusted, bulging or otherwise negated wiring. The boots on either side may need to come off to look up inside for broke wires as well. Usually it's pretty evident which wires are messed up but sometimes you have to do a little digging.

• When you find the broke wire[s] splice some new wire[s] in and use electric tape to re-insulate.

• This is a common problem across the board with many car manufacturers and repairing the harness almost always is the fix in a situation such as yours.

• Hope this helps.

SOURCE: 1999 ford explorer power windows won`t work will

suspect body control module

SOURCE: fuse box diagram for a 95 ford explorer

my ford explore is not reading mileage

SOURCE: Have a 98 ford explorer

it could very well be the starter solinoid mounted on fender under hood. most fords are setup this way. to test it -- You could use jumper cable to jump the two large studs on the solenoid together, which should make the starter crank the engine, assuming the engine can rotate freely. If jumping the solenoid works, then the solinoid is probably bad. have a good day !!

Marvin

• 85242 Answers
• Posted on May 13, 2011

SOURCE: 1999 ford explorer will not trun over act like it

Hello
I need a bit of clarification on this problem, are you saying the starter turns/cranks the engine over but it fails to start and run, or are you saying the starter doesn't crank the engine over at all?