Everything works the car just stopped running all the dash lights the signals everything still works but the car wont even turn over has the switch gone bad?
SOURCE: 1995 Chevy Monte Carlo
you need to take the upper and lower steering column covers off, should be 3 screws in bottom, take tilt steering lever out if neccessary, it is a 2 peice cover, take apart, change switch and put back together
SOURCE: how do you change the dash light bulbs on a 1995
The gauge cluster is removed by taking out several screws from the surrounding plastic panels, and two screw sticking upwards into the ceiling of the recessed area of the gauges. A trim-panel fastener removal tool can be very helpful for prying up the plastic panels once all of the screws are removed. There are metal clips that will hold the panels in place once unscrewed, and short sharp prying movements with this tool will usually disengage these clips. You may want to wrap some tape around the pry tool to avoid marring adjacent surfaces. You will probably have to move the steering column to it's lowest position and if the shifter is on the column, put it in 1st gear (with engine off, of course), to slide the gauge cluster itself out over the wheel. There will be a couple of plastic wiring harness connector behind the cluster which should be disconnected before pulling the cluster out fully. Be careful not to stretch or crimp the cable for the shift position indicator when working on the gauge cluster. Once you can reach the back of the cluster, you will find small plastic circular twist-in fasteners, each with a raised ridge across the middle. The come out easily with a 1/4 counterclockwise turn. The larger ones usually hold common #192 or #168 style small bulbs. The smaller ones often have permanently attached bulbs in them, and are replaced as whole units. These are usually stocked at local dealerships. Just make sure to match the part numbers when replacing them. Reassembly is the reverse of removal. Be careful to align the metal clips with their slots before giving the plastic panels a firm smack to reseat them. If misaligned, the clips will bend and give you much trouble.
SOURCE: 03 chevy monte carlo can't turn key
You may have a bad tumbler. Try rocking the steering wheel back and forth while turning the key. Sometimes the steering wheel lock puts too much pressure on the tumbler and the key won't turn. If that fails you will need to replace the key and tumbler.
SOURCE: i have a 1995 chevy monte carlo that I hae
Do any dash lights come on when you turn the key on? Does it crank over?
SOURCE: My ignition switch on my
First be sure its not the security system shutting your starter off. Next time it doesn't start, look for a light on the dash that says security. If you see this light, its not the ignition, its the security. Here is a link for that. http://vatspasslockpasskeysecurityhelp.yolasite.com/
203 views
Usually answered in minutes!
×