My security system in my Buick Le sabre is wired wrong..how do i get my car to crank

Steve Allison

• 5569 Answers
• Posted on Oct 12, 2008

SOURCE: temp sensor switch

They are almost always located on the bottom tank of the engine's radiator. They can have one or two wires (some are grounded to the tank and require only one) and are generally cylindrical with a hex section near the mounting surface to installation and removal.
You will need to catch the coolant when removing it and don't forget, it's a pretty large quantity of liquids.
When I have been in doubt whether one was defective or not, I have attached leads to monitor continuity and heated them in a container on the stove with a candy thermometer in the same water to watch the temperature rise. If OK, they should contact at some value below 212 degrees F.

SOURCE: 1997 buick le sabre

its the electrical connection at he fuel pump,if this is ok ask if they replaced the strainer on your fuel pump,your fuel pump is inside your gas tank ,you have to drop the tank to service,most fuel pumps are not warrantied if you dont change the strainer,when your car shuts off the sediment on the strainer falls back into the tank,but when you run your car and it sucks up the gas thru the strainer to the pump it clogs the strainer and the fuel pump cant pump,you shoiuld find out if they changed this because your forcing your fuel pump to work harder,was it a new fuel tank or used one that they put in

SOURCE: coil wire firing order

2.8i cd v6 ford galaxy

SOURCE: 1998 buick le sabre won't start.battery is

sounds like the starter

SOURCE: Where's the fuel filter on 2000 Buick Le Sabre and how to replace

release the pressure firs like take gas cap off there are some speacil tools called quick release tools some people just use a small screwdriver to pop it off it should be on driver side by the drivers door under neath the car if its a four door this driver door im talking about