I had the same problem the passenger seat stopped working
I located the problem in the motor , i send the 12 volts to the black and white wire
needed a chik start with my fingers once start to spin was ok
the same in reverse polarity
seems a dead spot on the motor , part number of the motor is 2088200842Temic 12v 083314gp41a35h210801-a2b
SOURCE: Driver's seat unable to move forward or backward
I have the same problem. I removed the motor assembly that powers the seat fore/aft and found a stripped plastic gear on the right-hand side of the driver-side seat track. It looks kinda like a speedometer gear. I was able to remove it, and hopefully Infiniti sells just the little gear.
SOURCE: The drivers seat is stuck.
Our 2002 has had this problem twice. The first time, we removed the 4 bolts holding down the seat, and jiggled the seat - it started working on it's own. The second time, the seat was too far back to get to the rear 2 bolts. We removed the front 2 bolts and tried to tap the motor - to no avail.... Later that day, the seat started to move again - but one side was stuck, and it seemed to have stripped a gear. Now it looks like a trip to the dealer...
SOURCE: My front seat will not move forward. It will
most likely the switch is bad if you disconnect the plug to the forward backwards motor the power should swap back and forth depending on which way thw switch is pushed if it doesnt switch is bad let me know how you make out
SOURCE: bmw z3 passenger seat goes forward backwards but
It can also be theseat motor since there is seperate motors for up/down & forward/backwards. You can test the switch to see if you are getting power to the connector on the motor by using a multimeter.
If there is power to the motor, I would remove the motor and give it a tap on the ground. Alot of the time the motor is fine, and the tap will free it up again. If it doesn't work you may be up for a new seat motor. Giving mine a tap solved the issue with mine.
SOURCE: Driver's power seat will not move backward
check fuse.if fuse is good check for power at seat motor.if yes replace seat motor.if no check wires at switch.if wires is not loose or broken seat motor switch could be bad.
681 views
Usually answered in minutes!
I opened the motor and start to look was the problem , I noticed that the dc brushes where no moving freely ,I cleaned and spray some W40 also I cleaned the rotor , I reassemble and I was able to save the motor,.the brushes still having some life left
×