When we plug our chargers into any of the power outlets they work for a bit and then lose power and then power right back up.. it will do this many times during a trip and i noticed that half of the radio lights do not work..what can i do to fix this problem as we would like to use these outlets for cell chargers and dvd use..
SOURCE: location of fuse box/panel for 2004 yukon denali xl
There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.
The ohter is under the dash and above the pedals, this one is much tougher to access.
Your Owner's Manual should tell you where the fuses are that you need to access.
SOURCE: power outlets dont work
I just purchased a 2002 Envoy and had the same problem. If you raise the drivers's side rear seat, you will see a big black box. Remove this box by pulling the bottom of the box outward and it will come straight up. Next you will see a black cover. This cover has a push tab on each end. Push
the tabs at the same time and lift up on the cover and it can be removed. Inside the cover there is a fuse diagram. The fuse number for my 2002 was #46. This fuse controls the front plugs and #15 controls the back plugs. Locate the the fuse puller on the top left, then count over to spare fuse #3. Between #3 and #4 the fuse is located about 1 1/2 inches below those fuses. You will see a yellow 20 amp pin fuse (BP/ATM-20RP AUTOZONE). remove and check fuse.
Good luck
Rick
SOURCE: Speedometer on 2004 GMC Envoy not working. It
There is a recall on the panel Cluster... call your dealer and have it checked out.. mention the recall... www.lemonauto.com
SOURCE: 2006 GMC Envoy XL gas gauge reads empty
The sulfur content in the fuel is contaminating the contacts of the sending unit.
Some people have had good luck with some fuel system cleaners solving this problem. The cheap stuff doesn't seem to do the job.
Not that GM isn't completely exonerated from fault but the gas stations don't do a very good job of watching what the stations sell.
SOURCE: 2002 gmc envoy xl front wheel bearing assy replace
take the wheel off,take the axle nut off,disconnect the spindle from the ball joint or joints, take the tie rod end out of the spindle and remove the spindle leaving the axle in the transmission. Now there is three bolts on the back of the spindle take theese out and beat the hub and bearing assy out. The new one wont be as hard to put in as the old one was to come out.
276 views
Usually answered in minutes!
×