No sound when pressing the button,checked and there is power to the switch that plugges into the window motor.Auto lock on the same driver side door won't work either.Power mirror works,lights work when opening the door and radio turns off when door is open.All other windows and locks work. Is this just a bad motor?
Check the electrical connections for you control switches...there should be at least two of them. Disconnect them and see if there are any recessed pins or dirt. Do this several times as there may be some oxidation on the connectors and doing this will help clean them off. The radio and door light works of the small limit switch on your door frame. Everything else works through the operators window/door lock control panel.
SOURCE: driver door auto--locks, windows, etc. not working. all other doors working
cable probably became disconnected in door..
SOURCE: Power door locks and driver side power window not
You can do it yourself.
Couple of times when you replace the remote battery, you might have them not working/ responding but just follow the procedure below.
Stand close to the car, hold down the open and close knobs for about 10 seconds. Press them at the same time for 3 seconds; then press the open button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
SOURCE: Power door locks and driver side power window not working
The solution to this issue was recently discovered during our most recent trip to the shop. We told them not to leave the window down when they changed the battery... BUT DID THEY LISTEN...NOOOO.
So quite by accident I was finally able to correct and then test fail the system and test and fix again...
Here you go.;
1. disconnect the battery and connect both the positive and negative cables together(after disconnected))
2. disconnect the window and lock controller in the driver's side door.
3. Leave cables connected for at least 5 minutes
4. Re-connect door window controller and locks wiring harness
5. Place the key in the ignition and turn to the run position
6. Connect Battery starting with the negative cable(ensuring not to connect then disconnect, (one swift motion)
7. open drivers side door and turn key to the off position(do not remove)
8. You should hear a series of dings
9 Once dings are heard remove the key from the ignition and you should hear the door lock solenoids activate..
10. Congrats.. Your done and the windows and locks work.
SOURCE: 2005 Chevy Colorado, drivers window, and door
check the control on the door some times is loos also the fuse on that door.
309 views
Usually answered in minutes!
×