The inside ligths not working - 2004 Infiniti QX56

Did you check to see if there is a fuse on the brake lights circuit?

If you changed the lamps and the brake switch it is obvious that they are not being energized.

1. 2-wires on each fog ligth
2. toggle switch 2-hook up
3. okay run hot wire from battery to one side of toggle
4. on fog ligths one wire migth be white or black
5. take one of the wire on fog ligth (white)&other fog ligth (white)wire
6. take a wire hook both white wire from both ligths an hook to this wire an run it to the other side of toggle
7. black wire on ligths hook them to ground
8. after you hook the ligths up an they work it best to put a fuse connector between one of the wires on toggle

your security system is activated. try turning the key on let set for 10 minutes turn it off then start. on some models it has to be done 3 times on off on off on off start. 10 minutes each time

Sounds like a fuse.

Should be able to check the fuses visually. Look for one that has the small metallic connecter (center of fuse) burned or broken. You can buy a small package of replacements from a part store. Ensuer the package has the correct fuse (there will be a color to the fuse, as well as an amperage printed on the top (i.e., 4A). Here is an image of what they typically look like: http://www.electronics123.net/amazon/pictures/afu.jpg.

Im not sure if this is going to be your problem but on f150s 250s 350s rangers and explorers, have very weak door switches that are used to tell the dome light to go out, when it fails the dome light does not go out if you have left the fuse out for the dome light there will be other problems, on most models the fuse that the dome light is on also controls the odometer, windsheild wipers and the electronic shift for the overdrive, generally a quick fix for the problem is to remove the bulb for the dome lamp, and insure the fuse is in properly, if you have map lamps in your vehicle these should still work, the only issue is you will not have a dome lamp when you open the doors only the map lamps youll have to turn on manually, If this does not fix the error with the overdrive most likely have shorted door switches throwing the circuit for a loop

you mat have a shorted bulb try changing the bulb if that doesnt work you probably have a bad ground

Broken wire OR bad ground wire. Check for corrosion inside the bulb receptical. Auto Parts stores have replacements.

bad brake light switch

Check the fuse in the fusebox inside for a blown fuse,the brake lights are working so check the plug going onto the back of the lamp for tightness,could be a loose connection.

the switch has gone out and needs to be replaced.