Low beam not working
Replace bulbs newer models are double contacted, normally if a lot of vibration and knocking around occurs this could short out and have it blown, also you may want to chek for slack connection on the contacts for the bulbs, again a problem due to vibration
SOURCE: Need Fuse Map Diagram BMW 318i 1993
check the internet for a bmw e36 ETM ( electronic troubleshooting manual) everything you need is there.
SOURCE: I just go locked out of my X5 BMW 2002 x5 and my
TRY TO USE THE KEY TO OPEN LOCK IF REMOTE WONT.TRY TO USE KEY ON THE PASSENGER SIDE TO SEE IF IT OPEN.
SOURCE: Reset oil light
Get in vehicle before turning key to 1st position, press in & hold odometor reset button while holding in turn key to position 1. after a few seconds reset will appear on screen release & push in again. it will ask you if you would like to reset, press again.
SOURCE: how do i change the hig beam bulb on my bmw x3
1. Open hood.
2. Use a small flat screwdriver to CAREFULLY pry open
cap leading to the headlight. Start directly underneath the tab that
says "V2." Be careful not to break the tabs! -- to do this simply push
the small screwdriver under the tab, as you push it in, you will hear the
clip release. The cap will pop and remove very easily after that.
3.
Pull out wire harness connecting to the bulb, push the spring clip in and to the side to release the clip and then you can pull the bulb out. Put the new bulb in (do not touch the glass portion or the bulb can explode from the oil residue) and reverse to close everything back up
497 views
Usually answered in minutes!
The bulb's were the problem. Thanks
×