At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
The cluster needs to be removed, then resolder the pins on the circuit board. you should be able to see the lil cracks in the existing solder on the pins..
My damn van would "quit" without notice, then start again weeks later.. i found a "quick fix" online by beating on the dash above the cluster to agitate the **** in there.. eventually that method became unusefull. So i did the resolder method.. not a single issue since.. entire time: approximately one hour for fix
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Where did you hear that one at . There isn't anything ,no connector ,no purple wire that gets corroded . Without proper service information , wiring diagrams etc... This diagnoses could take sometime . There is a ppl wire from the PCM / Crank fuse 10amp located in the instrument panel fuse box . When you turn the key to start B+ voltage is supplied to that fuse . from there it goes to the PCM crank sense input . From there the PCM energizes the starter relay sending B+ voltage to the starter solenoid . Turning over the engine . Suggest you look at a wiring diagram at http://www.bbbind.com/free_tsb.html Enter your vehicle info. year , make , model , engine size . System (engine ) Subsystem (starting )
The last time I saw this, it turned out to be a bad ECM due to shock. This was a Grand Caravan which didn't have any major damage as a result of the colision.
From your description of the problem, I would suspect either the ignition switch itself is starting to fail (large heavy key rings hill help that along) or your starter relay on the fuse panel. You can swap the relay with another like relay on the board and see if the problem moves or just replace it.
you need to call the gm part department and ask for a fuse diagram they can print you out one so you can keep it wwith your vehicle. Please rate my response thak you very much
hi not as simple as that have you checked all the fuses and corresponding relays and wiring connectors there is a web site that gives you the wiring diagrams for the security systems if you are ok with wiring diagrams then you will either be able to by-pass or or put a remote start switch in but as i said it is not a five miniute job if you want i can send you the sites details yates210456
have you had some one turn the key on and someone listen for the fuel pump by the back of the van. gthe fuel relay is ussally on the passenger side kick panel under the dash right next to the collission relay
×