Question about 2004 Jeep Grand Cherokee

1 Answer

My 2004 jeep grand cherokee has misfirein cylinder 6 and governor pressure 3# code. It has been misfiring at idle after changing from platinum plugs to copper core. I switched back to platinums and it got worse immediately. As it warms up it gets worse and worse to the point that it kicks in to limp mode. I have chaged the plugs, cleaned the pvc, cleaned the cranck case vent, cleaned the IAC. what is causing this?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 5,478 Answers

Sounds like you may have a problem with the coils.

Posted on Mar 09, 2019

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: IAC Valve Location - 1996 Jeep Grand Cherokee

The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body. 
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order. 
 To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.

Posted on May 28, 2009

Anonymous

  • 13 Answers

SOURCE: 06 wrangler 4 cylinder... keeps going thru spark

Pull the plugs and compare them to the pictures in repair manual, ie: Chilton's or Hayne's. May be a bad injector flooding them or an intake leak causing a lean condition.

Posted on Jul 31, 2009

Anonymous

  • 29 Answers

SOURCE: 2001 Jeep Cherokee with 6 cylinder engine -- PO306 code cylinder

Plug, plug wire, plugged or open fuel injector. are the most likely.

Posted on Sep 28, 2009

Anonymous

  • 41 Answers

SOURCE: Spark plug gap for 2004 jeep grand charokee for

The spark plug gap should be posted on the emissions sticker under the hood. The gap setting posted on the sticker is good for all brands and types of plugs for your vehicule

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 jeep grand cherokee is skipping and misfire codes


There are several different things that could make it misfire ! not just plugs ,does it have plug wires or is it coil on plug coils. Could have a coil breaking down. Does it do it in all driving conditions ? Idle , cruising speed ,under a light load and what codes .po300 random misfire or a specific cylinder misfire code ? P0306 cylinder #6 etc.

Jan 12, 2015 | 2007 Jeep Grand Cherokee Overland

1 Answer

2004 Jeep grand cherokee ODB code p1762, p1763


both those codes are for your transmission governor pressure sensor .and your pressure sensor .to fit them drop the pan in your gearbox .remove your filter chance to change that will it is off. now you can see both your parts.pull off the plug from your governor pressure sensor and replace.now pull off the pressure sensor and replace it.i do not know your level of skill to understand this.you may need a garage to do this.

Apr 20, 2013 | 1999 Jeep Grand Cherokee

1 Answer

04 Jeep Grand Cherokee/ P0303-possible vaccum leak


That code i think is a Cylinder 3 misfire.

May 28, 2012 | 2004 Jeep Grand Cherokee

1 Answer

Rough idle random cylinder misfire


misfires are more from problem injectors, low fuel pressure or injector wiring than from plugs
have a fuel pressure test done to check for problem pressure regulator , problem fuel pump , blocked m/dirty filter
one other area of concern is the EVAP system where the purge valve doesn't vent the tank properly and causes low fuel flow rates

May 27, 2017 | 1999 Jeep Grand Cherokee

1 Answer

Cylinder 4 misfire, someone said plugs? if so what type or brand is recommended. Idles rough/and stutters-shutters esp a speed up to 50mph.


I use Bosch platinum plugs in my Jeep Grand Wagoneer. I recommend nothing less than double platinum. Bosch makes a platinum plug with 4 electrodes - these are great because you don't have to set the gap on them. I have an 8 cylinder and these plugs aren't exactly cheap, but, with these rising gas prices, they DO make a difference in performance and mileage. Hope this helps!!

Jan 04, 2011 | 2000 Jeep Grand Cherokee

2 Answers

96 jeep cherokee misfires on cylinders 5 and 6 already replaced plugs, wires, cap, rotor, and injectors


do a compression test on cylinder 5 & 6 you could have intake leak.and a leaking head gasket or worn valves in those cylinders.

Dec 13, 2009 | Jeep Cherokee Cars & Trucks

3 Answers

1999 jeep cherokee 6 cylinder engine light


1.Plugs
2. Vacuum leak
3. Injector fault
4. High or low fuel pressure.
Thats the list of things to check.
This is a #3 cylinder misfire.
There is also TSB about #3 injector needing added heat protection. This could definitely be the cause. I start at plugs and go from there.
Hope this helps.
Thank you,
Lee

Dec 12, 2009 | 1999 Jeep Grand Cherokee

1 Answer

2001 Jeep Cherokee with 6 cylinder engine -- PO306 code cylinder


Plug, plug wire, plugged or open fuel injector. are the most likely.

Sep 28, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Code p1762 is appearing on my jeep dashborad


Governor Pressure Sensor Offset Volts Too Low or High

Mar 22, 2009 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...