Why wont car keep running after 10 seconds dies .replaced fuel pump already.
SOURCE: location of fuel pump relay on e-450 v-10?
The Fuel pump relay is in the Power Distribution Box under the hood, it is relay K. If it is the fuse then fuse 17 in the PDB.
It could also be the cut off switch, which is either under the dash above the brake pedal or behind the passenger kick panel
SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
SOURCE: 2005 ford ranger fuel pump relay gets hot and engine dies
Like Laurie Mack said. It is the inertia switch below the glove box. Here is some funny information. DON'T change the fuel pump first. Interesting fact: I bought the new inertia switch from Ford and the install instructions that came with it said to install the switch in the protected area to the right where the fuses are. It is like Ford knows it was a dumb place to put the inertia switch, but they won't let you know until after you buy a new one. I have read at least 20 other people on here that had the same problem I just had.
SOURCE: 98 expedition starts then after 15-20 seconds engine dies..
Replace the idle air control valve. Mine just did it today the 15th of August. I replace the Idle air control valve and problem solve. I have a 2000 Expedition 5.4 liter.
SOURCE: 2005 ford focus died restart push the gas pedal
replace relay in engine compartment fuse box.
130 views
Usually answered in minutes!
×