I have put in a new switch a new power window motor ,ANOTHER harness in the door ,ican unplug the window motor and test for voltage coming from the switch and it has voltage from the switch if i plug up the window motor and test for voltage and it has none please help , p.s. i did but another power window relay still not fix problem
Sounds like your ground part of the circuit is not working. Check in the door opening for broken wires-that's where they get stretched and break. Identify your ground for the windows that comes from the switch and goes into the cabin to a ground location-like behind the kick panel under the dash, maybe located there. You can use your multi-meter to check continuity of ground wire and also if the ground is good. Like this: your red lead to a wire or terminal that has power on it. Then connect your black lead to the ground wire terminal at the switch. If the meter shows voltage, then you know the ground is good. If the ground is not good, the meter won't register. See?
SOURCE: Power window problems on driver side
It sounds like there may be a short in the wires. Check the wiring inside the door jam. the wires should be within a rubberised sleeve, possibly a blue and tan coloured wire.
Marc from Barrie
SOURCE: location of blinker fuses for 1993 mustang conv
Front seating area, driver side, under dash, driver
side of pedal support bracket. the flasher is mounted in there also
good luck
SOURCE: Drivers door power window control stopped
Since it is only happening on the drivers side door to multiple switches and lights on that door only, I think the problem is the wiring harness as it enters the drivers door by the door hinges.
SOURCE: 2000 ford taurus driver power window not working
should be a fuse in engine compartment drivers side black box and there will be fuses for each sep. window.chech the fuse-under box cover the fuses are labled.if fuse good may have bad switch-check <remove switch from panel after removing panel.check with key on for power at switch if power is good press switch chech power on motor by removing wire connector and test with light/meter at connector.if power good motor bad>hint motors are interchangable so you can use rear drivers motor for example before you buy anouther motor.i have 4 good ones if you need :-> [email protected]
190 views
Usually answered in minutes!
×