I got this error code 3 months back and it said throttle position sensor error. my mechanic suggested to change the tps sensor. i ordered the part (whole throttle body) from chevy agency for $ 310 and replaced it. but now my car shows this sign again and since last 3 weeks and now car engine stops by itself while on the go. mechanic said i have to replace throttle body again to get it fixed. please suggest any solution!!!
Should not have to pay for same part twice.take vechicle back to dealership tell them car not fixed you have same problem.let them know you payed them to fix car.same problem still exist.code p2135 problem could be the tps sensor or signal circuit to sensor wires and connector have a short or problem could be throttle body assembly damaged.
SOURCE: Chevy aveo error codes. I have a check engine light on.code p2135
P2135 Throttle Position Sensor (TPS) Property Malfunction, remember this is not a car that is built by GM it is a Korean import.
SOURCE: How do you replace a throttle position sensor on a
This is a picture of your throttle position sensor. It is located on the throttle body, where the air inlet tube enters the intake manifold. Simply unplug the wires, remove the bolts holding it in place, and replace it with the new unit. Hope this helps!
SOURCE: Replace Fuel Filter on 2006 Chevy Aveo Hatchback
If the fuel filter is mounted inside the fuel tank at the pump it does not need replacing and is a permanent filter. All you have to do it follow the fuel lines from the fuel tank to the engine. If the filter is mounted in the fuel line you will find it.
SOURCE: tps location on 1999 camaro
TPS is always connected to one end of the throttle plate shaft It should not be difficult to identify. If you already have the new one the old one is identical. Usually fastened with two small torx screws.
SOURCE: how do I replace a headlight bulb in a 2006 aveo
you can access the bulbs from inside the engine compartment. the socker turns about a quarter turn to remove it. do NOT touch the bulb with your fingers as that will shorten the bulb life. you may have to remove the battery to change the one on that side.
This is a picture of your throttle position sensor. It is located on the throttle body, where the air inlet tube enters the intake manifold. Simply unplug the wires, remove the bolts holding it in place, and replace it with the new unit. Hope this helps!
4,982 views
Usually answered in minutes!
×