SOURCE: 01 olds aurora
bank 1 sensor 1 will be in exhaust manifold by firewall in the middle. bank 1 sensor 2 will be behind convertor .bank 2 sensor 1 will be in the front manifold down at the end of it
SOURCE: Where is the Knock sensor located in an Olds
the sensor is in the water jacket lower part of the engine block, u are lookin in the right place, u do need the car up so u can get to it from underneath, u can't see it from up top.
SOURCE: How many oxygen sensors are in my 95 oldsmobile
LOCATIONS
There are different locations in the exhaust system where O2S sensors are positioned. The locations have been given numbers and will be used in the accompanying charts to identify the positions of O2S sensors in most vehicles.
Due to mid-year production changes or factory inconsistencies, all models may not be covered. If a vehicle being serviced is not covered in the charts, inspect the exhaust system (while cold!) in the general locations to find the applicable O2S sensors.
NOTE: If equipped with dual exhaust systems, there may be up to 4 or 5 O2S sensors in the exhaust system. Be sure to locate all of them before commencing with any testing or service.
Fig. 1: Location No. 1 — down pipe or exhaust manifold
Fig. 2: Location No. 1 — typical O2S sensor located in the exhaust manifold
Fig. 3: Location No. 2 — left and right banks of a V-type engine
Fig. 4: Location No. 3 — exhaust collector (where more than one pipe joins together)
Fig. 5: Location No. 4 — outlet of the catalytic converter
Fig. 6: Location No. 5 — inlet and outlet of the catalytic converter
SOURCE: 01 olds aurora 4.0 low coolant light on. Where is
The coolant level sensor is inside the coolant bottle. It is not replaceable separately. You will have to replace the reservoir to replace the sensor.
492 views
Usually answered in minutes!
×