Already bled them and tested they worked fine but then after i parked it for a while they got spongy again
SOURCE: Spongy brakes after bleeding them 2 times. Should I try to bleed the master cylinder or replace it?
Honestly your guess is as good as mine. But I don't think the master cylinder is NOT bad you still have air in the system. Get a big bottle of brake fluid bleed all four sides until you run out of fluid or your brakes work properly. You should divide the bottle's content in four, then use each quantity in each side. You'll be removing air and contaminated fluid from the system. Get a small hose that fits on the bleeders and an appropriate container. I have a good feeling if you do this your brakes will work just fine. I don't know how you are bleeding the brakes. I'll let you know the proper way just in case. This is a two man job, with the wheel off, have someone start the car. Have them pump the brakes a few times to get pressure. 1With the brake pedal UP open the bleeder, 2then have your assistant press the brake pedal all the way down and leave it completely pressed down. 3Close the bleeder valve, once close and only with the valve closed have'm release the brake. Repeat as necessary, bake depressed, open valve first then press brake. DO NOT depress until valve completly closed. Close valve THEN depress. Good Luck!
SOURCE: 2005 f150 spongy brakes
it sounds like your still not getting all the air out of your lines. it helps to have a brake bleeder but they are expensive, it also could be that the gasket inside the master cylinder is inverted even if it is a new master cylinder this could be the case, ive had four bad remanned ones in a row, before i got a good one... hope i could help
SOURCE: I have a 2003 Expedition that the pressure on the
Check that the master cylinder is backing off enough. Check for binding brake pistions.
820 views
Usually answered in minutes!
×