How do I change the language from spanish to english in a hummer h3
SOURCE: i want to reset the hummer 2008 h3's dashboard
switch ignition on. press instrument switch on off until oill reset appears then hold switch down for about 5 seconds and listen for faint bleeping noise oil is then reset.
SOURCE: how do i shut off my change oil light in my h3
I'm not 100% on this but I think it's like a lot of GM's; turn the key to the "on" position(not running), stomp the gas pedal to the floor 3 times within 5 seconds & the light should flash & go out.
SOURCE: 2006 H3 Hummer AC/Heater Fan Motor
I brought my 2006 H3 in to the dealer for the same thing. My blower stopped working all together but it started as an intermittent problem. He said he had to replaced a diode or resistor either behind the switch on the dash that controls the fan or on the fan motor itself. Have not had a problem since but that was only about 4 months ago.
SOURCE: How often do i need to change my oil in my 2008 h3 hummer
follow the owners manual, usually 3 to 5 thousand miles, oil does not go bad but it absorbs contaminants, and can only do so much, also check any filters
SOURCE: 2006 H3 Hummer fan problem
Hi if your internal fan not work in any position well i fixed up myself easy and save your money.
locate the fan motor air just outside right courtesy drawn document in front of passenger. go from down and look up you will see a motor with a big connector white with 2 screw secure inside the motor block. loose the two screws and pull out gently the connector from motor fan block. you will see a green multiresistor connected with this big connector. Usually the first + voltage connector is burnet out. disconnect the connector pull from resistor and check for any burn. in my case the first pin was burned out completely
you can buy another connector or you can clean the burned connector take out form connector weld a small copper cable of 5 mm dia from resistor to the burn cable and reconnect the connector without buy a new one. after replace again the resistor in the hole of motor blow with the 2 screw.
Done all work again without buy another new connector.
Gabriel from Italy Turin
H3 hummer 2007
loveling one and Humvee owner
3,175 views
Usually answered in minutes!
×