I need solution to my TPMS SENSORS
SOURCE: change front rotors kia rondo 2007
Remove the tire, remove the brake calipers, 2 bolts on back side of rotor, remove the carter pin that retains the bolt position if equiped, remove the center nut. When you pull the rotor off watch for a set of bearings to drop out. To install the new rotor reverse the process.
SOURCE: 2007 Kia rondo interior lights stay on when headlights turned on
sound like a manufacturer problem go straight to kia dealership explain to them whats going on/ when you bought the vehicle was it doing it then
SOURCE: disable tpms
I don't know if there is a problem with your TPMS receiver (on dash board), or your TPMS sensor is disable (in four tire). If it's the receiver problem, You have to go to the dealer ship to solve the problem. If it's the sensor problem. You can go to the dealer ship to let them find which sensor or sensors are fault, And replace them by the new one then doing the reset process.
SOURCE: engine light came on kia 2007 rondo
you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is
SOURCE: After replacing a broken tire pressure sensor the
The 2006 tire pressure monitoring system will automatically reset after driving approximately 20minutes above 20MPH. It is important to note that if you go below 20MPH during this diagnostic drive cycle the counter in the TPMS module wil reset requiring you to start over. The easiest thing to do is go on a highway. If after this drive cycle the TPMS warning light is still in you most likely have another problem in the system with a code stored in the module.
820 views
Usually answered in minutes!
×