Window in sliding side door nedds to be replaced-how to install it?
Hello, You can follow simple steps suggested by Smallwood Renovations LLC -
1. Apply Silicone Adhesive
2. Place sliding window
3. Add shims
4. Secure windows
5. Cut shims
6. Install Hardware
7. That's it.
If you need more brief details then consult us for window installation Richmond VA.
Window Replacement Service and Window installation Richmond VA
Installing windows or doors at your own is not so easy and also risky too. There are various service providers providing such repair and replacement services at minimal cost. Windows and Doors repair and replacement services are also available online. http://windowmedics.com/
SOURCE: rear sliding glass window
If u r going to buy a new one, instructions will be included, if u have plans to purchase a used one from a salvage yard, they aren't too difficult to install, the worst part is removing the old glass, and that's already done! Rubber glass seal around outside should be in place, put a rope inside the seal (where the glass will go) leaving a couple of feet or more hanging out at the end. Put the glass in between seal edges as much as you can w/out forcing. W/ a helper, slowly pull the rope out as u push the glass into the seal, the rope pulls back the seal so the glass can slide into the channel. If u have any trouble, don't insert the rope all the way around, this way more of the glass will fit in the rubber channel (seal). Good luck, let me know how it works for u. countrycurt0
SOURCE: drivers side window
The glass should bolt to the window channel on the bottom of the window. Roll the window all the way up and duct tape it to the top of the door.
1,104 views
Usually answered in minutes!
×