Car goes into limp mode, even after resetting by disconnecting battery terminals what could problem be
That happened to my '95 OLDS Aurora... Turned out to be 1&2 gear shift solenoid had "popped" out. He replaced new solenoids and a factory patch kit and ****** shifts like brand new. Hope that helps you cause that was less than 10% the cost of a new/rebuilt transmission!
SOURCE: 1998 honda accord transmission goes into limp mode
the vehicle may have a electrical problem and or mechanical problem in the trans....id try replaceing the solenoids and then the entire transmision and torque converter.
SOURCE: automatic transmission is stuck in 2nd gear (limp mode)
most newer vehicles have transmission control modules,that go to a default of 2nd or 3rd gear when they go bad! I had a 91 plymouth stuck in 3rd gear because of this module! could be your problem! when mine went out, it smelled like something electrical burned inside the the passenger cabin! I would check all the electrical connections on the transmission first good luck
SOURCE: 2002 Chrysler Town and Country limp mode
Hello, I have the same problem with my 2002 neon. I was told it was the solenoid pack. I purchased one on eBay (the garage want around $200) for $88. I also bought on eBay the input and output VSS(vehicle speed sensors) for $25 for both. Autozone has these sensors for $27 each. I am going to replace these parts in a day or so to see if it helps.I dont have a garage and its cold outside here in West Virginia. I have also been told to check the ground straps to make sure they are getting good connections. They are located at the starter. I will let you know how this turns out for me when I do the repairs. I have been reading many forums where others are having the same problems. If you have learned anything from your experience please let me know.
Thank you,Dave
SOURCE: 94 Lebaron GTC 2nd gear limp in mode
It has an electical problem. You need to take it to the dealership if you want it diagnosed correctly. It will need to be in limp in, and don't turn the car off as this is clearing the code out of the computer. Leave it running, tell the service advisor your situation and not to turn it off till someone can hook the scan tool to it. This will give them the cause of limp in, and should be able to be resolved after.
SOURCE: automatic transmission is stuck in 2nd gear (limp mode)
it is eletical eather a fuse is blown or the speed sensor didnt get hooked up dose spedo work
445 views
Usually answered in minutes!
×