This can be cause by many things... (Mainly by a faulty EGR valve) or bad exhaust. If you haven't found a fix yet... Are you able to stop by an Auto Zone or Advance Auto Parts? If so, ask them to place a code reader onto your OBD reader. Let us know if there is a code, or if you need more help.
I look forward to helping you out
SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited
do you mean they are sticking?
SOURCE: Where is the factory amp
The amp relay is in the Relay/Fuse box located under the hood. The amp relay is the one labeled NBS which stands for Name Brand Speakers.
If you are trying to install an after market radio in a 2001 Chrysler Town and Country, you may notice that no sound comes from the speakers. This is because the single wire that is connected to the factory radio sends a signal to the Bus which tells the relay to turn on - powering the factory amp.
I bypass this by running a wire from the red Acc power wire on the radio to the relay. Connect the wire to pin number 87 on the relay. When standing in front of and facing the van, pin number 87 is the pin, on the NBS relay, which is closest to you and furtherst right.
Are you looking to replace the amplifier? or bypass the speaker wires??
Usually factory amplifiers in vans are under the P/S Front seat. However they can be up under the dash as well (P/S).
If you're looking for it because it is not turning on - check the relay (as above).
Thanks for using FixYa - a FixYa rating is appreciated!
SOURCE: radiator fan relay,2001 chrysler town country
the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays
SOURCE: 2001 Chrysler town and Country tire size
the sticker on the drivers door or door jamb will have that info. plus it is on the side of the tire, starting with P___-__-__
SOURCE: replace the input speed sensor on a 2001 chrysler
The input speed sensor is located directly below and a little to the right of the cooler lines that are going into the transmission. IF you are standing in from of the car, remove the air breather or anything else that prevents you from getting down in on the driver side. There are two seemingly similar plugs at 9o'clock to the rear of the motor. The one closest to the motor is the input, the one further back is the out put.
It just unscrews and you screw the new on in.
Hope this helps
107 views
Usually answered in minutes!
By bog out could you clarify exactly what you mean? Are you saying it stalls or misses?
×