When shifting into 4th gear it jumps out in to 2nd the safe mode i guess.and does the same using auto stick..123 work fine no 4th both ways.when it goes to 2nd you can stomp on gas and it knocks it out to use 3rd in auto stick thats only way it comes out.it use to clear it up buy shutting car offf and restarting it now it doest help it..any ideas please.
Ecp/pcm reprogram / update
If you need further help, reach me via phone at https://www.6ya.com/expert/james_9c1b039055413ffa
SOURCE: The A-604 ultradrive transmission goes into 2nd gear or neutral at ANY speeds
I've rebuilt hundreds of these transmissions through the years,typical parts lists range from solenoid blocks and TCM's to completely wiped out gear trains.Typical price for rebuilding that trans with new electricals included is any where from $2000-$3000 with a 12/12 or 36/36 warranty.
SOURCE: 94 Lebaron GTC 2nd gear limp in mode
It has an electical problem. You need to take it to the dealership if you want it diagnosed correctly. It will need to be in limp in, and don't turn the car off as this is clearing the code out of the computer. Leave it running, tell the service advisor your situation and not to turn it off till someone can hook the scan tool to it. This will give them the cause of limp in, and should be able to be resolved after.
SOURCE: Cant get my Lebaron too shift into 3rd gear
Vehicle Speed Sensor or Variable Speed Sensor (located on the transaxle - closest to the drivers side front tire. it has a two pin connector)
SOURCE: Chrysler Neon auto gearbox problems
P0733 IS GEAR RATIO ERROR IN 3RD AND P0734 IS GEAR RATIO ERROR IN 4TH..THESE CODES USUALLY MEAN AN INTERNAL PROBLEM IN TRANSMISSION,BUT CHECK WIRES AT SPEED SENSOR CONNECTORS FOR BROKEN WIRES BY PULLING ON WIRES AND WIRING NEAR SOLENOID PACK FOR CHAFING..I HOPE THIS HELPS..YOU MIGHT WANT TO DROP THE TRANS PAN AND LOOK FOR A PLUGGED FILTER OR DEBRIS IN PAN..MAKE SURE THE TRANS COOLER IN RAD HAS NOT FAILED ALSO
SOURCE: were in the transmission is the shift solenoid
Chrysler shifting is controled by a computer. When you turn off the car and restart it you in effect rebooting the computer thats why after you do it the car works fine.
222 views
Usually answered in minutes!
×