Wiring aftermarket stereo to replace original radio (AM/FM only- 4 speakers)
Ok this is for the factory wiring,The wire colors are for the right rear speaker are,dark blue is positive,light blue is negative.Right front door is light green is positive and dark green is negative.Left front,tan is negative and gray is positive.Left rear is brown positive and yellow negative.Hope this helps.Good luck.
SOURCE: needing wiring diagram for 1991 dodge dynasty le
here is what I found:
http://www.the12volt.com/installbay/stereodetail/715.html
SOURCE: Identification of original wiring to car radio/stereo
no wiring diagram needed go cut a plug from a junk yard and wire it into the cut wires then buy the adapter kit for you car and wire that to the car plug and the radio plug.
SOURCE: stock wiring diagram?
Constant 12V+ Light Green
Switched 12V+ Yellow/Black
Ground Chassis
Illumination Blue/Brown
Dimmer n/a
Antenna Trigger n/a
Front Speakers 5 1/4" Doors
Left Front (+) Green
Left Front (-) Black/White
Right Front (+) White/Red
Right Front (-) Black/White
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.
SOURCE: Installing an aftermarket stereo in 1996 explorer...sound issues.
Does the new stereo come on? Check that you connected the speaker wires correctly. Both positive and negative speaker wires from the stereo need to be connected to the speaker leads in the vehicle.
Testimonial: "I do have power to the radio and it turns on and says that the CD is playing, but there is no sound. I'll have to try again."
SOURCE: installing aftermarket stereo. cannot locate a
BEST BET IS TO GO TO A STORE THAT SELLS &INSTALLS.... I,VE HAD THEM MAKE A COPY OF A SCHMATIC BEFORE... ,CHARLIE
7,866 views
Usually answered in minutes!
radio wiring
×