SOURCE: Cam Shaft Sensor Problems
Had the same problem before on my 04 Neon SXT...camshaft sensor is on left side of engine block, take out the battery and to the left of it (face car) is the camshaft position sensor. To change it you'll have to move a few hoses but its plan to see there on the left side of the engine...pretty easy remove and replace. Fixed my problem of car not going above 2k RPM when i replaced the sensor.
SOURCE: I have a 96' Dodge Neon, and my car wont start!
Check the timing belt. Sometimes the timing tentioner goes bad in them.
SOURCE: 96 Dodge Neon O2 sensor
That would correct the problem, the O2 sensor is on the exhaust manifold or on the exhaust manifold down pipe. If you go to Auto Zone, they will have the O2 sensor you need and also the loaner tool you may need to remove the O2 sensor. Auto Zone also can give you the step by step instructions to replacing the O2 sensor in about 30 min. Once you located the O2 sensor, disconnect the wire harness and use the O2 sensor socket to remove the sensor from the exhaust. It's like removing a spark plug, to install the new O2 sensor is just to follow the same procedure in revers to the removal. Good luck.
Testimonial: "Gosh, I can't believe how fast you answered. Thank you very much."
SOURCE: Dodge neon 2001 will not crank at all. battery is
solenoid is part of the starter so best bet is to remove and have tested at an auto parts store.
1,223 views
Usually answered in minutes!
×