Can't open glove box in my 2003 Aztek

Video instructions here

https://www.google.com/search?q=open+a+2018+Honda+CRV+glove+box+with+a+broken+latch

..

Sounds like the locking / latch mechanism is either locked or broken, try to remove the glove box after removing all the screws that secure the hinges on the glove box.

Hope it helps.

best thing is to take it to a locksmith and see if they can open it

check under the glove box door to see if you can see the hinges. Sometimes you can unscrew the hinges from the bottom. Else you have to knock out the hinge pin on both hinges, open the door from the bottom and see if you can swing the door up to undo the latch.
If this does not work, cut a hole in the bottom ot the glove box, it is usually made of plastic or papier mache, release the latch from inside, then you can remove the plastic box once it is open and replace it with a new one. It will cost you, but it will be less expensive that breaking down the metal door!

Its a common problem with the 2003-1007 accord. You will need to replace the glove box latch assembly. If you can find it separate! Most of the junk yards sell a complete glove box. You could check ebay? 03 04 05 06 07 HONDA ACCORD GLOVE BOX OEM

just glue the broken part! Walmart Heat Bond Ultrahold No Sew Iron On Adhesive 17 5 yds

if the latch and lock are already broken, then use a pry bar or screw driver and break it open. that is the only way...

Remove the glove box: unscrew 3 screws inside the box (in a row towards the top) and 2 on the outside (one on the bottom right side- open the car door to access it, and one on the bottom left side). Grab the bottom of the box and pull it toward you. It will come off.

Once it's off, flip it over. There are 2 screws that hold the latch housing on the box (you'll find them in the 2 circles that are cut into the plastic). Unscrew them.

Next, flip it back over to the front and stick a small flat screwdriver between the latch housing and the glove box part that it's stuck into. Gently pull the latch and the whole thing should come out.

Pop the new one in, replace the screws, put your glove box back in your car, and you're good to go!

you will have to pry it open and then replace the latch.good luck

your going to have to pry open, latch may have broken.