2003 Ford Explorer XLT, three windows stopped working; master switch replaced; no power to the three buttons that are not working; only power on front passenger at switch which works; any suggestions?

SOURCE: 2005 ford explorer front end noise.

Try lubing any bushings with a silcone spay lube i have ran into this before and the bushing on the sway bar links get dry and make a squeeking noise.

SOURCE: 2003 explorer front passenger window regulator/motor replcement

You will first need to remove the door panel on the inside. Then you will need to remove the window glass from the track it rests in. Then you need to undo all the screws that attach the regulator inside the door. At the top of the door where the glass slides up and down remove the inner and outer window track guides. Then very carefully maneuver the regulator up and out the top of the door. Reverse the procedure to replace. It sounds easy, but you need to almost be double jointed to do this. So, have great patience while doing this task. Good luck.

SOURCE: Location of Speed Sensor 1998 Ford Explorer XLT

If it has RWAL only, the sensor is in the rear end. If it is ABS brakes, there are speed sensors on the front wheels as well. If there is in fact a speed sensor in the tranny, it is most likely internal.

SOURCE: 02 Ford Explorer XLT 4x4 High light flashes and

I had same problem on my 2002 explorer. Its either the computer module, or the electric solenoid on the transfer case. In my case it was both. The computer module I had done twice in 14 months.

SOURCE: 2002 Ford Explorer passenger power window problem

Check the fuse panel first, after that check your fuse relays under the hood, if not then it might be a wiring problem.