1 & 2 work fine- in overdrive the engine revs going to 3rd-let off gas & it shifts, but no 4th gear. Will not shift to third in drive at all. I changed the shift solenoids (both) and the VSS- still not shifting properly. No metal in the pan when I dropped it- fluid at bottom of pan was thick and sludgy.
SOURCE: 4l60e slips in 3rd and 4th
There are to many things that can cause this problem, best thing to is go get the ECM scanned for DTC codes at a transmission shop or Auto zone or Parts Source since they scan for free.
The ECM should have DTC code in it's memory on how the transmission is Performing and have the Transmission line tested for Fluid pressure.
Good luck and hope this helps. Oh and also ways check with more then on transmission shop if there tell you that you need a new Transmission,
It could be a simple as the transmission filter falling off causing the lost of transmission fluid pressure. Check the transmission fluid too.
SOURCE: 1993 chevrolet blazer fullsize 4l60e trans problem
first of all shavings are a bad sign likely internal damage has occured
SOURCE: My 4L60E transmission will not shift into reverse or overdrive.
Needs rebuilt... www.TransmissionGarage.com
SOURCE: 4l60e going from 1st to 3rd and dont have overdrive any more
You most likely have a broken sunshell inside the transmission. They tend to go out when the transmission is shifted to drive when while still rolling in reverse.
SOURCE: 3rd and 4th gear slipage in 4l60e
Try the vacuum line to the kickdown solenoid. If its not cracked your tranny may need to be rebuilt. Flushing and filter may help also.
3,716 views
Usually answered in minutes!
×