SOURCE: where is the orifice tube on 1998 cavalier
the orfice is located in the liquid line, this line runs from the condensor to the evaperator core, disconnect line at the core first and look in line and core side if its not there then look at the other end at condenser.
SOURCE: I just changed my air condition system
on pass side underhood you will see reciever/drier(large line goes to it,Then you will see small ac line by it,disconnect small line, orfice tube is inside it.
SOURCE: How to change spark plugs of Chevy cavalier 2002
for the most part they are in between the fuel injector the best thing for you to do is stop by your local GM dealership in the part department and they be able to print you off the pictures and diagrams you need if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car Merry Christmas and Happy New Year as always wish you the best of luck Michigan Man.
Testimonial: "great thanks for the info. bobbotg2005"
SOURCE: I am trying to locate
The expansion (orifice) tube is located at the condenser to evaporator tube connection IN the condenser tube.
SOURCE: we are trying to either
It is located inside the condensor tube running to the evaporator.
Here are the removal/installation instructions as per alldata:
TOOLS REQUIRED
J 39400-A Halogen Leak Detector
J 26549-E Orifice Tube Remover
REMOVAL PROCEDURE
-Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
-Remove the air cleaner assembly.
-Remove the vacuum brake booster.
-Remove the condenser tube.
-Use J 26549-E in order to remove the expansion orifice tube. IMPORTANT: DO NOT use any solvents or chemicals to clean the porous plastic inlet filter of the expansion orifice tube.
-Inspect the expansion orifice tube for the following conditions and clean or replace with a new tube as indicated:
-Broken plastic frame (1); replace the tube.
Inlet filter (3) damaged or plugged with fine gritty material; replace the tube.
Inlet filter (3) coated with metal chips, flakes, or slivers; remove the coating with low pressure shop air ONLY and reuse if the filter is cleaned satisfactorily. Do NOT reuse the O-ring seals (2).
INSTALLATION PROCEDURE
IMPORTANT: Lubricate the new O-ring seals (2) with mineral base 525 viscosity refrigerant oil.
If you reuse the orifice tube, install new O-ring seals (2).
Carefully grasp the edge of the expansion orifice tube (1) without touching the inlet filter (3) and insert the expansion tube into the condenser tube until fully seated.
-Install the condenser tube.
-Install the vacuum brake booster.
-Install the air cleaner assembly.
-Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
-Leak test the fittings of the component using J 39400-A.
6,042 views
Usually answered in minutes!
×