This is more of a question than an answer,..but it appears no one seems to know anything about identifying which serpentine belt to use,..there are two listed for the 2004 Toyota Camry 2.4 liter engine. One belt is designed for engines with the "enhancement" and another belt was designed for 2.4 liter engines WITHOUT the "enhancement" My question here is,..How do you know if your 2004 Toyota Camry has this "Enhancement" installed or not.
SOURCE: Need a serpentine belt diagram for 2004 Toyota
Sorry for the delayed response.
CLICK on the following LINK. It has the Serpentine Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
Thanks.
http://www.2carpros.com/car_repair_information/year/2004/make/toyota/model/corolla/2004_toyota_corolla_drive_belt_routing_diagram.htm
SOURCE: how to remove the serpentine belt of a 2004 toyota
Actually you don't have to do all of that. I just replaced one from the top. On the passenger side of the engine where the belt is, you will see the tensioner in the middle. Using a larger breaker bar with the socket that fits the bolt in the middle of the wheel, force the tensioner toward the front of the car to release pressure to remove the belt. I think it was a 15mm but can't remember for sure. I do know they are all metric sizes on that engine. The tricky part is to remember how the belt is routed. If you forget, see the diagram below. There isn't much room to work, but I'm proof that it is possible. When putting the new best on, route all pulleys and leave the alternator for last since it's right on top and easy to get to. Good luck and be patient. It's doable.
SOURCE: i dont have a diagram to run serpentine belt to a toyota camry 03
Hi
Replacing Serpentine belt on a Toyota camry 2003—
Step 1--Examine the belt placement of your Toyota Camry fan belt so that you will remember how to put it back once you have removed it. Refer to the vehicle owner's manual for further information. Locate the pivot bolt on the front passenger side of the engine. Loosen the pivot bolt with a socket wrench.
Step 2--Loosen the adjustment locking bolt that is just below the tensioner pulley with a socket wrench, and then loosen the tensioner pulley to allow the belt to move free.
Step 3--Check the belt for any signs of cracking or irregular wear, so you can fix any problems that may exist with the pulleys. Remove the fan belt from the pulleys on the engine and take it out of the engine compartment.
Step 4--Wrap the new fan belt around each of the pulleys the same way it came out. When you have the belt in place, tighten the tensioner pulley with a socket wrench.
Step 5--Tighten the adjustment locking bolt and the pivot bolt with a socket wrench, and then look over the engine to check that everything is back in place.
Step 6--Turn the vehicle engine on and watch it for a few minutes to verify that everything is operating properly, then turn the engine off.
Please refer to these links for serpentine belt diagrams—
Serpentine belt on a Toyota camry Link 1
Serpentine belt on a Toyota camry Link 2
Please do accept the solution and revert for further assistance.
Thanks
Rylee
10,654 views
Usually answered in minutes!
×