How to change a crankshaft sensor in a 2005 Dodge caravan

SOURCE: location of crankshaft position sensor

it is located on the rear of the engine behind and below the alternator.

SOURCE: 04 Dodge SRT 4 crankshaft sensor

The Crankshaft Position Sensor is located directly next to the starter.

1. On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
2. Remove the Structural Collar
3. Unlock and disconnect the electrical connector to the crankshaft position sensor.
4. Remove the crankshaft position sensor bolt.
5. Remove the sensor

Greg Bernett

• 2993 Answers
• Posted on Mar 21, 2009

SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE

Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?

SOURCE: 2002 dodge stratus crankshaft sensor location?

The crankshaft or the shankcraft as we refer to it is inside the engine, it turns over the pistons. Never heard of such an animal. You may have a fuel pump going out, clogged fuel filter, fuel injectors, Idle air control valve going out, bad plugs, plug wires or distributors. Just began checking them one at a time.

SOURCE: 2005 dodge grand caravan getting code p0406

3.3 engines has the egr valve with transducer.you have to replace the whole unit. code p0406 what its trying to tell you your egr valve circuit is short to ground.it has failed .