The first thing I would check is fuel pressure. This type of fuel injection requires a minimum fuel pressure in order to operate. If fuel pressure is as little as one psi below minimum the vehicle will not start.
You can try squirting a couple of shots of carb spray into the air snorkel while somebody cranks the engine over. If the engine starts and then dies you now you fpdeffinetely have a fuel issue.
If the engine still won't start check for spark.
Let me know what you find.
Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
SOURCE: oil pan removal on 2002 gmc sierra
did you pull the rubber plugs between the motor and trans out? there are either nuts or bolts up there
SOURCE: how to align a 94 gmc sierra
Inner and outer ball joints?? If you mean tie rod ends u will need to set the toe in. Mesure the distance across the back of the tires and then across the front. The differance is ur toe in. Best take it to a wheel align shop and have it done properly it will save you a lot on tires.
SOURCE: I need the firing order for a 2003 vortec v6
1-6-4-5-3-2
clockwise rotation
front - 2-4-6
rear 1-3-5
good luck!
Testimonial: "thanks for the help."
SOURCE: 4l60e tranny swap
No the 4l60e is a electronic transmission you need to find a 700r4 transmission which are very common. Check with your local junk yards and are pretty easy to install. About a full days worth of work for a person with general know how of vehicles.
644 views
Usually answered in minutes!
×