Power windows will not go up or down
For all types of power window problem and power windows not working,i suggest you to go through the help links given below. Click the link to go through its procedure to troubleshoot the problem :------ Power window problem Power windows not working after car wash?http://howtobyme.blogspot.com/2011/11/power-windows-not-working-after-car.html power locks, power window and power mirror not working? Complete Diagnosis & Testing Power Windows? http://repairhelpcenter.blogspot.in/2012/02/diagnosis-testing-power-windows.html
http://repairhelpcenter.blogspot.com/2012/01/pontiac-grand-am-power-window-not.html
------------
---------
http://howtobyme.blogspot.com/2011/09/power-locks-power-window-and-power.html
------------
All power windows not working?
http://howtobyme.blogspot.com/2011/09/all-power-windows-not-working-on-2003.html
------------
How to remove window motor and regulator on Car?
http://howtobyme.blogspot.com/2011/09/how-to-remove-window-motor-and.html
-------------
-----------This will help.Thanks.
SOURCE: How to replace a 1997 Grand Marquis window
If it's the same as my 94 I think the answer your looking for is drill out the rivets (replace them with bolts). First remove the glass (also riveted in). The regulator ( without motor attached) comes out of the glass opening in the top of the door. Getting the interior door panel back on was the hardest part.
SOURCE: Mercury grand marquis 1997 temperature control
I'm not sure if yours is identical to mine since yours is second gen and mine is third gen, but with mine (1998 MGM), the heat was stuck on all the time. Full heat would practically cook your feet and you couldn't shut it off.
It was a servo/servo arm that controls the hot/cold mix door. The part was $15. The labor was $700. They had to take the entire dash out of the car to get at the part. Required two more visits due to a missed electrical connection to a daylight sensor and a vacuum issue that made the car stall when put into reverse.
My car had 150K on it at the time. Has 165K on it now. Still runs great and looks great. It's now my wife's auto and I drive a 2006 MGM.
SOURCE: How to install a new power window motor in my 1993
Remove all screws to door panel. Remove the lock and window controls. Then take large flat-tip screwdriver and gently pry directly next to plastic studs holding panel on to door. Lift door panel off. Remove plastic out of the way. You will now have access to window motor. You may have to solder off old wiring. Or if you have enough to cut, would be good
SOURCE: I have a 1997 Mercury Grand Marquis. The hotwater
Check your antifreeze with a antifreeze checker to make sure it is at the right temp depending on where you live and how cold it gets there. If you have too much antifreeze the engine temp will not come up to over 200 and also replace your thermostat, making sure to realize they make them in different temp settings. Talk to people and make sure the thermostat you install is the right one for your climate where you live. Sounds to me as though your temp never comes up to what it should be. Also it could be the heater core.
SOURCE: 1997 mercury grand marquis. no distributor. all
Down load a service manual for your vehicle from this website
http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717
1,631 views
Usually answered in minutes!
×