1997 Ford Crown Victoria Logo

Related Topics:

Tiffany moss Posted on Jan 18, 2012

My trunk won't open in my 97 crown Victoria

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jun 29, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jun 29, 2013
Answers
1
Questions
0
Helped
1101
Points
1

HOW BROKE IN A 1998 CROWN VIC TRUNK

5 Related Answers

bill

  • 234 Answers
  • Posted on Aug 29, 2009

SOURCE: on 97 crown victoria when i turn wipers off the go

sounds as though the park switch ground has gone bad, you will need a new or reman wiper motor.

Ad
c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Oct 12, 2009

SOURCE: Hi, How do I replace the tail light bulbs in my

Sedans

  1. Remove the screw(s) and wing nut retainers at the rear of the luggage compartment and push the trim away from the back of the light.
  2. Remove the wing nuts retaining the light assembly to the vehicle and the retaining nut from either side of the luggage compartment and pull the light body assembly from the vehicle.
  3. Turn the bulb socket(s) counterclockwise to the stop and remove the socket(s) from the light assembly. Remove the bulb(s) from the socket(s).
  4. Installation is the reverse of the removal procedure.
56c16fa.gif
Push the trim away from the back of the light—1992-98 Crown Victoria

f147c29.gif
The rear tailamp assembly is held by various fasteners

da5bd90.gif
Remove the wing nuts retaining the light assembly to the lower back panel—1992-98 Crown Victoria

e896b59.gif
Remove the nut retaining the light assembly from the side of the luggage compartment

2e1520f.gif
Pull the light assembly away from the vehicle—1992-98 Crown Victoria

Testimonial: "I was thinking I would get to the bulbs from inside the trunk. This info makes perfect sense. Thanks"

Anonymous

  • 324 Answers
  • Posted on Nov 26, 2008

SOURCE: Ford Crown Victoria overheating

your head gaskets are bad, this is the only thing that will cause this problem.

Anonymous

  • 37 Answers
  • Posted on May 27, 2009

SOURCE: I need to get my 97' Crown victoria trunk open from the inside.

There should be a safety trunk release located on the upper rear window deck platform- a black handpull . If it is still intact- it should pop the trunk lid.

Anonymous

  • 279 Answers
  • Posted on Jan 31, 2010

SOURCE: Where is the fuel pump shut off switch located on

The fuel pump inertia switch is located on the passenger side kick panel,Behind the plastic cover.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Need to pop trunk open to get keys out of the trunk on a 95 Ford crown Victoria

In some large cars like yours you can remove the rear seat back and open a plate that gives access to the trunk. Depending on your car if it is just a small access panel you will have to go on a fishing expedition with a magnet attached to a rod of some sort to fish them out.
0helpful
1answer

How do i open a trunk to a 1996 Crown vic? I can't use a key and i can't open from inside because my battery is dead?

There should be a safety trunk release located on the upper rear window deck platform- a black handpull . If it is still intact- it should pop the trunk lid. At least it works that way on a 1997 Crown Vic.
0helpful
1answer

My 97 crown victoria died suddenly while driving down the road and won't restart

Is the fuel pump coming on? Turn the key to on position and listen by gas tank for a humming noise for fuel pump. Check the accident fuel shut off switch in the trunk, it should be on driver side in trunk, behind carpet- pad. if the button is up. Push it down to reset.
0helpful
1answer

Hi Stephen, what do you know about a 1983 Ford Crown Victoria? Runs great, then stalls and won't start. replaced a few things already, still the same. Any ideas?

have you checked into the fuel throttle sensor (throttlebody)?? im haaving issues right now as well with my 2004 explorer
0helpful
1answer
0helpful
1answer
0helpful
1answer

Ever thing works but my 2005 crown victoria won't start, what do i need to try

You didn't provide any sounds or anything
you may have checked so far

Did you test the battery?

Is the battery 6 years old,that you would know.

Are the cables corroded or loose?

Does the starter solenoid click,that could be bad
or the starter it's self

What about the head lights or any other power

What does work is my question
You need to come here with something
to work with
1helpful
1answer

2000 crown victoria won't start after i got a new battery and altenator. What can the problem be?

The starter or it's solenoid

The new battery & alternator didn't
but the problem in there
2helpful
1answer

I need to get my 97' Crown victoria trunk open from the inside.

There should be a safety trunk release located on the upper rear window deck platform- a black handpull . If it is still intact- it should pop the trunk lid.
0helpful
1answer

How to replace rear turn signal on 1995 crown victoria

open the trunk and remove the trim panel closest to you whare the latch is. now pull the carpet down on the side you need to fix, remove the 4 nuts holding the lamp assembley, pull the lamp assembley straight out from rear of vehicle .
Not finding what you are looking for?

1,111 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...