1995 Toyota Camry Logo

Related Topics:

A
Anonymous Posted on Feb 02, 2018

How can i reset my airbag light on a 1995 camry

My light was working fine. all i did was remove the dash panel and wires, to replace a bulb in the drive light indicator. unpluged the wires from the speedometer and replaced after i installed the bulb. started car fine and noticed light on. im thinking i should have unpluged the battery first.

1 Answer

cbmprinting

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Passionate:

Visited the website for 10 consecutive days.

Habit-Forming:

Visited the website for 3 consecutive days.

  • Expert 95 Answers
  • Posted on Feb 02, 2018
cbmprinting
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Passionate:

Visited the website for 10 consecutive days.

Habit-Forming:

Visited the website for 3 consecutive days.

Joined: Dec 03, 2009
Answers
95
Questions
1
Helped
30226
Points
307

Should not have anything to do with the fact you did not disconnect the battery it sounds more like you have nocked an air bag sensor that may be on its way out.
The thing is they are to important to play with if you take to an auto electrician they can reset the computer.
Then if it comes on again you may need to spend some $
Let me know how you go.
Regards Craig

5 Related Answers

Anonymous

  • 3 Answers
  • Posted on Nov 21, 2008

SOURCE: DOME AND DASHBOARD LIGHT BULB REPLACEMENT

just have your star screu driver take off the speedometer cover take out the speedometer and replace bulb. and also take out the door mat and replace bulb.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 25, 2009

SOURCE: Replacment of a dash light. Toyota Corolla 1998

There is a plastic garnish surrounding the instrument cluster held in by 2 philips head screws. remove the screws and gently pry the garnish from top first then sides then it should pull out.

Then remove the 3 screws holding the cluster in place (2 bottom 1 top). Once that is done gently flip the cluster bottom up and pull out some to expose the wiring harness. Remove the 3 connectors from the back and then the cluster will pull out.

There are 3 bulbs that control the overall lighting of the cluster. They are spaced about every third across the rear of the cluster. They are the larger Green knobs. Remove the 3 large green knobs and replace the bulbs with the appropriate size. You can call your local parts store to find out the size.

Its a 5 minute job and does not require the entire removal of the dash board.

-ASE Master Tech
-Lexus Senior Tech
99 Corolla Owner.

Oscar Agnes

  • 347 Answers
  • Posted on Jan 01, 2010

SOURCE: 1990 Camry Fuse Diagram. The following suddenly

REPLACE BUSTED FUSES

Anonymous

  • 164 Answers
  • Posted on Jan 09, 2010

SOURCE: 2000 Toyota Camry instrument panel gauges not working

check the fuses in your manual it will tell you which fuses are for the dash and replace them it sounds to me like they are blown! good luck

Anonymous

  • 89 Answers
  • Posted on Feb 04, 2010

SOURCE: I need to reset my airbag light on a 1995 Toyota

go to http://www.vehix411.com it will show you how to reset it if it dosent reset it will show you how to diagnose it all free

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hi my airbag light is not coming on in my Holden Bering 2006. How do I replace the light? Thanks

you think the bulb has blown on the dash

remove the dash panel and replace the bulb

should be screws and maybe a plastic shroud
0helpful
1answer

How to replace ac panel light bulbs on toyota camry

remove control panel from dash use flat tip screwdriver to unlock bulb sockets from rear of control panel reverse to install
0helpful
1answer

Airbag light reset code

You would need to reset the warning light and then see if it comes back on, which would indicate a fault still there. Try this procedure

http://s16.photobucket.com/user/rogersb/media/AirBagReset.jpg.html

"How do you reset the airbag warning light in a '94 Camry?
A: Clearing the warning light in '92-'96 Camrys by the following procedure:
In the DLC1 or DCL2 (data link connector under the hood, see following diagram)
Use two short wires, one wire at terminal TC and a different wire at terminal AB
With the ignition key ON - wait 6 seconds, then:
Ground terminal TC to good body ground for one second
Then ground terminal AB for one second
Then TC one second
Then AB one second
Then ground TC until the light blinks.
Make sure the interval between grounding terminals is not more than 0.2 sec.
Remove the ground wires
Be very careful to only use the correct terminals."
1helpful
1answer

My passenger side airbag deployed on my 1995 Camry. I can't get the dash cover to close. Any suggestions?

Need to take to manufacturer/dealer and/or a private company to have the airbag replaced. Otherwise you need to cut the airbag out and replace the panel on the airbag (unsafe)
4helpful
2answers

Air bag reset 1995 toyota camry

I haven't had to try this but here is a procedure for resetting the airbag after the battery was disconnected


"How do you reset the airbag warning light in a '94 Camry?


A: Clearing the warning light in '92-'96 Camrys by the following procedure:
In the DLC1 or DCL2 (data link connector under the hood, see attached diagram):
Use two short wires, one wire at terminal TC and a different wire at terminal AB:
With the ignition key ON - wait 6 seconds, then:
Ground terminal TC to good body ground for one second
Then ground terminal AB for one second
Then TC one second
Then AB one second
Then ground TC until the light blinks.
Make sure the interval between grounding the terminals is not more than 2 secs.
Remove the ground wires.




Be very careful to only use the correct terminals.
8_11_2012_5_40_39_am.jpg
0helpful
1answer

In my 2005 pontiac sunfire the dash board light is deam on the speedometer so how do i change the light bulb out

FIRST TURN OFF RADIO TO KEEP FROM LOCKING OUT.THEN REMOVE NEGATIVE BATTERY CABLE WAIT 20 MINUTES UNTIL AIRBAG DISCHARGE.YOU WANT TO DISABLE AIRBAGS IN THE STEERING WHEEL OR DASH ANY TIME YOU WORKING AROUND STEERING WHEEL OR STEERING COLUMN OR WORK AROUND DASH AREA AIRBAGS NEED TO BE DISABLE.YOU NEED TO BUY A HAYNES REPAIR IT WILL SHOW YOU THE CLUSTER SCREWS LOCATION SO YOU CAN LOCATE SCREWS AND REMOVE CLUSTER TO REPLACE BULBS.
2helpful
2answers
0helpful
1answer

I have just purchased a '96 Toyota Camry. The

remove your entire dashboard and diconnect all wires find bulb and replace. They don't make it easy. Don't feel bad it's just as hard on all cars. Good luck!!!
1helpful
2answers

Lower brake lights on 92 camry wont work

YOU MAY NEED A LIGHT FAILURE SENSOR WHICH IS LOCATED IN THE TRUNK ON THE DRIVERS SIDE
0helpful
2answers

AC panel lights 05 camry

those bulbs cannot be replaced individually, you have to replace the whole ac control panel.
Not finding what you are looking for?

511 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...