Security alarm I recently bought a 1993 Toyota Camry V6 Automatic. I guess it came with a security alarm that comes on at will Often, all the central locking system becomes active while driving. I have asked the technician to work on it with no success. The security remote control came with it but no longer works. Can I ask the technician to disable it. Dayo

Glas to assist.



First, remove the black box from the security wiring harness; 3 connectors.



Then, remove the plastic moulding on the driver side rocker, the kick panel, the panel under the steering column, and the lower dash cover.



Now, pull the harness towards you, pulling it under the seat carpet.



Pull out all of the wiring, and then observe where the connectors plug into the factory dash harness.



Unplug the wire harness that you just pulled out, connector by connector. Then, plug the factory harness connectors back in (the scurity harness simply interupts the factory harness), one by one.



You will see a red & green wire going up under the steering column. Find the wire crimp and remove the wire.



Remove the ground wire from the ground bolt. Make sure that the entire security harness is disconnected, and all of the factory connectors are connected in the place of the now-removed security harness.



Throw the black box and the security wire away.

Note: if you just remove the black box, the car will not start; you have to remove everything.



This may sound like a lot of work, but, it really is not hard, nor is it time consuming.



Hope this helps; I'd appreciate a FixYa rating for my assistance. Thanks. Glas to assist.

First, remove the black box from the security wiring harness; 3 connectors.

Then, remove the plastic moulding on the driver side rocker, the kick panel, the panel under the steering column, and the lower dash cover.

Now, pull the harness towards you, pulling it under the seat carpet.

Pull out all of the wiring, and then observe where the connectors plug into the factory dash harness.

Unplug the wire harness that you just pulled out, connector by connector. Then, plug the factory harness connectors back in (the scurity harness simply interupts the factory harness), one by one.

You will see a red & green wire going up under the steering column. Find the wire crimp and remove the wire.

Remove the ground wire from the ground bolt. Make sure that the entire security harness is disconnected, and all of the factory connectors are connected in the place of the now-removed security harness.

Throw the black box and the security wire away.
Note: if you just remove the black box, the car will not start; you have to remove everything.

This may sound like a lot of work, but, it really is not hard, nor is it time consuming.

Hope this helps; I'd appreciate a FixYa rating for my assistance. Thanks.